R65 Type transmission Disconnect battery. To improve access to switch you could remove the air cleaner. Disconnect the the wiring connector to the switch which is located on the side of the gearbox. Unscrew the switch and remove. Refitting is the reverse of above but a new sealing ring shoukd be fitted.
PG 1 Type transmission
As above for battery. Jack up car, switch is on top of the gearbox. May need to remove the under shield to get at the switch. trace the wiring back from the switch until you come to a connector and disconnect. Refitting is reverse of above but a new seal should be used.
the unit bolted to the left of the front cam housing ....
the rover model is early rover 200 series ie, 214, 216.
would like a picture
fuse for the immobiliser which one is it
hi its to do with your airbag sensor usually found at the front bumper looks like a small black box with wires at rear hope this helps
yeah i'd also like to know that!!
One for the engine, one for the transmission.
down by the clutch pedel, closer to the radio tbh,
0.85mm, but .8 or .9 will do fine also.
Look in the removable housing at the engine end of the upper radiator hose
Just been looking myself and is 30.
The fuel pump is an in tank unit and is located inside the petrol tank.
You need to remove the transmission oil pan. Use an oil pan to catch the old fluid that will come out. Replace the filter while the pan is off and replace the pan gasket.
11 nm then 2 x 180 degree turns
216 = 216
2163 = 216 x 216 x 216 = 10077696
The LCM is 216.
Any major brand that meets the specifications outlined in your owners manual. Use the weight listed there.
23% of 216= 23% * 216= 0.23 * 216= 49.68
48% of 216= 48% * 216= 0.48 * 216= 103.68
LCM(8, 72, 216) = 216.
It is 216 = 65536It is 216 = 65536It is 216 = 65536It is 216 = 65536
There are infinitely many possible answers. Two of the simplest answers are 216 + 0 = 216 and 216*1 = 216.