answersLogoWhite

Be the first to answer!

Who doesn't love being #1?

Be the first to answer this question.

Related Questions


I'm Trying To Change The EGR valve ON My 1999 Nissan Quest How Difficult Is It Going To Be, Please Help


I think the changes came in 1999, then Ford quit making the Quest and Nissan took over in 2004. If i recall, there was no 2003 Quest.


What is the spark plug gap for a 1999 Nissan Quest w/ 3.3 engine?


The Nissan Quest uses a good quality 5W30 oil


in the front near the radiator


There are at least 3 bulbs in the 1999 Nissan Quest. You must open up the dash (instructions provided elsewhere on this site for that - it starts with the center panel....) to get to them. The likelihood that all went bad together is very remote.


HOW CHANGE BRAKES ON NISSAN MAXIMA


how to change waterpump on 1999 Nissan Sentra 1.6 engine


Your local auto parts will have a how to manuel with step-by-step directions. You might also try searching within Nissan forums for tips and tricks.


The 1999 Nissan Quest radiator fan resistor is attached to the back of the fan motor. The resistor should be labeled as such.


Located diretly behind the center console and it is a real pain to get to. Try buying the Haynes manual for the Mercury Villager/Nissan Quest and it helps somewhat.



remove belts idler is to close to fire wall to come off after you remove nut.jack up car and put stands under.how put a jack under engine . remove top motor mount bolt and jack engine up this will give you the room to change idler pully.


How do you change the spark plugs in a 1999 Nissan Altima. Can not get socket on the plug.



check with your local Nissan dealer,,on the 1999 they were recalled,,I had a 1999 frontier,and they repalced it for nothing,,,


The 1999 Nissan Maxima does not have a cabin air filter. It never came with one.


how to change the brake light in a Nissan frontier 1999


Yes, a competent mechanic can do it without trouble. It is a complex job, but not that difficult.


u have to pull the fuse under the hood that's marked sec


In the 1999 Quest GXE (and I expect this is true for all Quest vans model years 1999-2002) it is underneath the driver's seat (on the outside of the vehicle) behind a black plastic panel. The 4 bolts holding the panel can be removed with a 10mm wrench.



U should replace them at 100 thous to be safe


we put off the replacement of the timing belt on our 1999 Quest at the recommended 90K miles. It broke at about 100K and ruined the engine....I replaced the engine because I liked the vehicle so much, but the guy did a poor job and I continue to have trouble with it. Replace that belt if you like your Quest!


I have a 1999 Nissan Altima and currently has 156000 on it. The manufacturer recomendation for the timing belt is every 75,000 miles.



Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.