0
Remove the floorplate, replace spring, replace floorplate
Wiki User
∙ 14y ago
To change the spring in an AR magazine, first remove the floor plate and slide the old spring out. Insert the new spring into the magazine tube and ensure it is properly seated, then reassemble the magazine by replacing the floor plate. It's important to ensure the spring is correctly positioned to prevent feeding issues.
Add your answer:
Earn +20 pts
How can you change the magazine catch spring in your TT33 Tokarev pistol?
Best left to a gunsmith
What are the components of the magazine body in the M9?
The magazine body is a component, and is one piece. The components of the complete magazine would be the magazine body, the floor plate, the spring, and the follower. US Navy Answer: Locking block plunger, Magazine spring, magazine tube, follower, floor plate.
What are the parts of a Glock?
Trigger with trigger bar, trigger spring, connector, trigger housing with ejector, locking block, slide stop, magazine catch, magazine catch spring, slide lock, slide lock spring, locking block pin, trigger pin, trigger housing pin, Frame, Magazine tube, magazine floor plate, magazine spring, magazine insert, magazine follower, front sight, extractor, rear sight, firing pin channel liner, extractor depressor plunger, extractor depressor plunger spring, Spring loaded bearing, spring cups (2), Firing pin spring, firing pin, firing pin spacer sleeve, slide cover plate, firing pin safety spring, firing pin safety, barrel, recoil spring assembly, 36 parts unless I missed one.
Will an M-14 magazine work in an AR-10?
No, neither on an original AR-10, nor on a current production model.
How do you insert a plug for a Remington 870 shotgun?
On the end of the magazine tube there is a threaded-on cap. Remove this cap. You will now find a "spring plug" inside the front end of the magazine tube. Carefully pry this spring plug out of the magazine tube. Put a pair of safety glasses in the proper location on your face because once you get this spring cap close to the end of the magazine tube the magazine follwer spring will push it out of the mag. tube faster than you can say"Oh sh.. crap". Once this spring cap is out you can pull the magazine spring out if it already hasn't landed in the living room. You can now insert or remove a cartridge number restricting plug. Next you'll need to push the extended magazine spring back into the magazine tube and re-install the spring end cap. To get the spring plug in flush with the front edge of the magazine tube, tap it into place with a plastic screwdriver handle to prevent distorting the thin walls of the mag. tube. Replace the screw-on end cap and that's it.
Can you put a spring in the stock of an AR-15?
Yes, that is where the recoil spring goes, push down on the detent and shove the spring into the tube
Where is the Evans Museum in Magazine Arkansas located?
The address of the Evans Museum is: 6335 N Hwy 109, Magazine, AR 72943
Why does your Smith and Wesson sigma pistol jam so much?
Mine doesn't. Possible problems - magazine, magazine spring, ammunition, limp-writsting, recoil spring.
What are the steps for m9 magazine reassembly?
It should have only been disassembled at operator level. You place the barrel into the slide, place the return spring into the slide, mount the slide onto the frame (pulling back the slide into place), flip the slide release up, then perform your functions check.
What are the parts of the m9 magazine assembly?
body, spring, follower
How many springs are in the ak-47?
Three.. bolt carrier return spring, trigger return spring, magazine release return spring.
Will the redimag weapons mounted magazine holder for the AR-15 fit two magazines that are coupled?
Depends on how high on the magazine the couplers are and how wide apart they are
