answersLogoWhite

0


Best Answer

You will need to jack up the front of the car a few inches,8-10.Disconnect the battery!! The starter is on the bottom and just about in the middle of the car about two feet back from the front of the car,mounted at the engine/transmission connection.

To remove the starter simply remove the positive cable from the screw post on the starter coil,remove the plug in connector located right next to it(pull straight out) and remove the two screws from the back of the starter unit,that's it.Installation is the reverse

User Avatar

Wiki User

13y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you change the starter in a 1992 Mitsubishi diamante LS 3L v6 dohc?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you set the timing belt on 1992 Mitsubishi Diamante EC 300 v6?

how i can set 1997 Mitsubishi diamante timing beltAnswerhow i can set 1997 Mitsubishi diamante timing belt


How do you find Mitsubishi engine ECU?

Make and model please 1992 Mitsubishi diamante


Where is ecu located on 1992 Mitsubishi diamante?

Underneath of glove compartment on passenger side firewall bolted on my two bolts..hope this helps


Wiring diagram for 1992 Mitsubishi magna?

A diagram for what component? 1996 magna starter circuit


How do you change the timing belt in a 1992 Mitsubishi mirage?

look up Mitsubishi forum, they got the answer there


How many car speakers are in a 1992 Mitsubishi diamante?

Six speakers in a 92-96 Diamante.Two on the dash,two in the front doors,two on the rear deck. Ern


Will the ecu off of a 1995 diamante fit a 1992 diamante?

NO, they are programmed differently.


How do you replace a starter on a 1992 Mitsubishi diamante?

You will need to jack up the front of the car a few inches,8-10.Disconnect the battery!! The starter is on the bottom and just about in the middle of the car about two feet back from the front of the car,mounted at the engine/transmission connection. To remove the starter simply remove the positive cable from the screw post on the starter coil,remove the plug in connector located right next to it(pull straight out) and remove the two screws from the back of the starter unit,that's it.Installation is the reverse Ern


What is the easiest way to change the solenoid on a 1992 Corsica?

What solonoid?? If it is the starter solnoid, you have to take the starter off.


Where do you find the PVC valve on a 1992 Mitsubishi Diamante v6 dohc 24 v?

front valve cover at the left back corner. It screws in to the valve cover. There is a rubber hose conected to it.


How do you change the antennae on a 1992 Mitsubishi 3000gt?

http://www.stealth316.com/2-antenna.htm


Why does Abs light stays on in a 1992 diamante?

It is just a sensor. My car, however is not a 1992 Diamante, but I own a 1998 Camaro and it is nothing but a sensor. It is nothing to worry about.