How do you change the starter in a 99 sunfire 22 liter?

Answer 1

Disconnect the negative battery cable at the battery. Raise and safely support the vehicle. Remove the electrical connections from the back of the starter. Remove the bell-housing cover. Remove the starter support bracket bolt from the engine block. Unfasten the starter motor-to-engine bolts, then carefully lower the starter. Remove the nuts/bolts that hold the starter support bracket to the starter. To install: Transfer the starter support bracket to the new starter if the starter is being replaced. Raise the starter into position and secure the starter using the starter motor-to-engine bolts. Tighten the bolts to 32 ft. lbs. (43 Nm). Install the starter support bracket-to-engine bolt to 24 ft. lbs. (32 Nm). Install the bell-housing cover. Install the starter electrical connections on the back of the starter. Tighten the S terminal to 22 inch lbs. (2.5 Nm) and the battery terminal to 106 inch lbs. (12 Nm). Carefully lower the vehicle, then connect the negative battery