a 15 socket can be used on one of the bolts but you will need a wrench to get at the other one as there is no room to get a wrachet up behind the bar that goes along there just simply put the wrench over the top of the bar and u can get at it from there as for the 15 scokey it is straight forward and by the way the wrench is a 15 also ...pretty simple..
Is it necessary to remove the oil pressure switch, the oil filter and the engine stabilizer bar, (and even the fan and housing)this is a very ambiguous answer above
Transmission control unit for a 1990 Pontiac transport?
Do what?
I have the same problem with a 1994 Pontiac transport. So if anyone has an answer please help us.
I have a 1990 Pontiac Transport SE, I have the changed the motor on the driver's window which is power...take off the door panel and you will see the motor...not too difficult of a job...follow the old motor route...
== ==
garage
The starter relay on a 1990 Pontiac Sunbird is typically located in the engine compartment, mounted on the firewall or near the battery. It's often situated in the fuse box or relay center. To locate it, you may refer to the vehicle's service manual for specific diagrams and details.
there is no 2.0l Pontiac lemans.it must be a swap from sunrunner.
Go to autozone.com. Sign up for free membership. This will give you access to repair guides that includes instructions on how to replace a starter.
I recently had a 1990 Chevy lumina apv 3.1L engine put into my 1992 Pontiac transport, if that answers your question.
The starter motor is about 8" long and cylindrical. It is found on the rear side of the engine, down low. Make sure that you disconnect the negative battery terminal first, because the power cable going to the starter is live. A couple of bolts hold it on to the bell-housing for the transmission.
last time I checked = 1-2-3-4-5-6...no kidding