answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: How do you change the tail light assembly on a 99 Oldsmobile bravada?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you change a headlight on 1997 Oldsmobile bravada?

open hood two pins with rubber caps hold lights in. pull them up and out light will then fall out change bulbs and reinstert pins


Where is fuse for dome light on 1997 Oldsmobile Bravada?

Dome light fuse for 2004 Bravada is fuse#4 (10amp) in fuse box underneath back seat on driver's side


How do you change head light 2002 trailblazer?

On my 2002 Bravada open hood and there are 2 clips that have to be lifted and entire headlight assembly pulls out allowing acces to bulbs-perhaps the same with yours


How do you change tail light on 2000 Oldsmobile Intrigue?

Remove the rear tail light assembly by pulling the carpet back and unscrewing three thumb screws. Pull out the tail light assembly and the bulb sockets will be visible. twist out the socket to access the bulb. Install is reverse.


How do you reset check engine oil light on a 2002 Oldsmobile Bravada?

I just had an oil change and the guy turned the key on (did not start car). Pumped the gas pedal three times simultaneous. Repeated with key off.


How do you change the brake lights on an Oldsmobile cutlass 1998?

Open trunk and pull carpeting back from the rear lights and you will see wing nuts, take the wing nuts off and pull the complete light assembly out to change the bulbs.


How do you change the license plate light on Oldsmobile Aurora?

It is very easy to change the license plate light on an Oldsmobile Aurora. All you need to do is remove the license plate and look above where the plate was. There are bolts that are holding the light in. Unscrew the bolts and then replace the light.


How do you reset the check engine light on a 1994 Oldsmobile Bravada?

You can disconnect the negative battery cable, wait a couple minutes then reconnect the cable. This will clear the codes and reset the check engine light but, if the reason the light came on isn't fixed the light will come back on soon.


How do you change rear turn signal bulb for a 2000 Oldsmobile bravada?

2000 Oldsmobile Bravada turn signal light bulb replacement: Purchase the correct replacement turn signal light bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Then consult your owner's manual for the turn signal light bulb replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).


How do you replace the fog light bulb on a 2003 Oldsmobile bravada?

most of the time, the bulb socket just comes out the back of the fog lamp. look on the inside of the front bumper for them. Should be easy.


Can you change the lense only on a head light on a 2005 Chrysler Pacifica?

No, you get an assembly.No, you get an assembly.


How do you turn off the light around the license plate on a 2002 Oldsmobile Bravada?

There should be a connector for the lights above the rear bumper, but you may not want to disconnect it because then your likely to get pulled over for having a faulty license plate light