0
How do you change the temperature blower motor in a 2000 Camry?
Wiki User
∙ 14y ago
Disconnect the negative battery cable. Wait at least 90 seconds to proceed work due to the SRS system.
- Remove the glove compartment.
- Detach the blower motor electrical connector.
- Remove the blower motor by extracting the 3 screws.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Why does your blower motor in Toyota Camry works on only high?
the resistor for the blower motor is busted blower works on high with out it
Where is the blower motor for 1995 Camry?
The blower motor is located on the passenger side under the dash and behind the glove box.
How do you change blower motor on 2000 Chevy blazer?
how to change the blower motor
How do you change a blower motor on a 1992 Toyota Camry?
The blower motor is on the passenger side underneath the dash. Its not hard to get too. It has 3 or 4 screws and it takes a little manipulation to get it out but its a simple job. Took me about 30min. to remove and replace it.
How do you change the heater blower motor on a 2006 Chevy Malibu?
how do i change my blower motor on my 2007 malibu
How do you replace a blower motor on a 2007 Camry?
on the bottom passenger side under the glove box remove the cover, locate the blower motor, disconnect the plug from it, remove 3 screws and the blower motor should come out.
How to Change fan blower motor on a 1983 Chevy Celebrity?
Are you asking about the heater blower motor or the engine cooling blower motor?
How do you change blower motor?
how tdo you change air blower for 1979 camaro
How do you change blower motor 1993 ford E350?
i cannot get the wheel off the blower motor
What would cause a Toyota Camry to only blow on high?
The blower motor resistor is defective.
Where is the blower motor for 2001 Camry?
Remove the glove compartment door. Should be somewhere in sight.
How do you change blower motor on 2001 corvette?
Remove the wiring harness from the back of your 2001 Chevrolet Corvette blower motor. Remove the blower motor retaining bolts. Remove the blower motor fan. Reverse the process to install the new blower motor.
