BUY..
A NEW THERMOSTAT FOR THE CAR 1ST
ANTIFREEZE
GASKET SEALER
Follow the top hose from the top left of the radiator back to the engine block, where the hose ends attached to a metalic dome (thermostsat housing), held inplace by a pair of 3/8 or 10mm bolts. Remove bolts and take em out of the holes (stops them flying off into the engine in a place where you cant get them back). Lift off the thermostat housing and remove old thermostat after checking which way it sits in place.
Use a clean rag to fill hole while you clean away any residual gasket debris. Fit new thermostat, Use gasket seal on the new supplied gasket replace housing.. and bolt down tight.. refill system with recommended antifreeze and run the engine and check for leaks and top up levels as required..
DIFFICULTY: Low 20 mins max
A 1993 Chrysler LeBaron is fuel injected and does not have a carburetor.A 1993 Chrysler LeBaron is fuel injected and does not have a carburetor.
It is located under the housing where the upper radiator hose attaches to the engine.
If same engine and transmission model, yes.
Show removel of trunk lock 1993 chrysler lebaron
No.
No
Green
I have a 1993 Lebaron with 3.0 Liter and Automatic. I get between 23-26 mpg.
They went from the hide-a-way lights to the molded lens in 1993.
Around 14 gallons
You can, but it is not required.
.044 inch