Follow the upper radiator hose from the radiator to the engine and at tne engine you will see the thermostat housing. Take out the two bolts and remove the thermostat and when you reinstall it make sure the spring goes toward the engine. You will likely need a deep socket set in order to remove the bolts. You may also need to remove the air filter in order to access the bolt to the rear.
Have a care when replacing the thermostat housing. The constant heating and cooling (and likely the chemicals in the anti-freeze) makes the metal brittle.
It should have a 195 degree thermostat.
Follow the upper radiator hose from the radiator to the engine. It is attached to the thermostat housing. Removing the thermostat housing will expose the thermostat.
An alternator from a 2000 Chevy blazer will fit a 2002 S10 blazer with a little fabrication.
Will a Chevy blazer engine fit in a Chevy s10 pickup
Will a 2000 blazer transmission fit a 1998 s 10 chevy 4x4 truck
We need to know what year that S10 Blazer is.
Chevy s10 blazer lug pattern is 5x4.75 with 6" back spacing
time for an oil change
Need to know what year and engine.
No it does not if it is a s10 blazer
i am looking for a diagram of the firing order in a 1997 Chevy s10 blazer 4x4.
Yes. Very easily. They are built on the same body, but the blazer is the suv and the s10 is the truck.
235x70x15 this tire size on my 2001 s10 blazer
how do you replace dome light in s10 chey blazer?
The temp sensor for the ECM (engine control module) is next to the thermostat housing.
You need only to drain off a couple quarts of coolant to change the thermostat.
The thermostat is under the housing that the top radiator hose connects to, remove the hose then the housing and change the thermostat. The bolts are metric so be prepared with the proper tools.
On the 4.3L it is located next to the thermostat housing. The electrical plug to it has two wires.
The ECM on a 1992 S10 Blazer is located below the glove box.
for chevy s10 blazer v-6
A 98 Blazer S10 has 5 lugs on each wheel.