Top Answer
User Avatar
Wiki User
Answered 2009-12-26 14:26:28

The temp sensor for the ECM (engine control module) is next to the thermostat housing.

User Avatar

Your Answer

Related Questions

A 1995 blazer does not have a crank sensor. SORRY

Answerp0137 or p0147 if it's the heater circuit.

The 95 don't have one. It was not used untill 1996

The 1995 Chevrolet Astro and coolant temperature sensor can be found on the front of the engine. The coolant temperature sensor will be a few inches above the thermostat housing.

Where is the idle speed motor located at on a 1995 chevy blazer?

its underneath the hose comming out of the intake about 5 inches out

where is the fuel shut off swith on a 1995 Chevy s -10 blazer at

The 1995 Blazer was rated at 5000lbs towing capacity.

Original manufacturer's tire size for a 1995 Chevy Blazer are P205/75R15 97S.

It means that the temperature is below 20 degrees Fahrenheit.

Iat / Idle air temperature sensor was not used on that year.

where can i buy a transmission dip stick for a 1995 chevy blazer

Should be right behind the grill attached to the center post,2 wires going in thin on top kinda fat where the plug goes

There is no Intake Air Temperature sensor on a 1995 only 96 and newer. If you are asking because you are putting some sort of performance module on it then you need to hook that up to the Coolant temperature sensor which is located next to the thermostat and it is a two wire sensor.

There are several, which one are you looking for?

The stock gear ratio for a 1995 Chevy Blazer is 3.73. This provides a good balance of fuel economy and power to the rear wheels.

They are lined up like this on my 1995 Chevy blazer 4.3 L, V6 1,6,5,4,3,2

Assuming this is a 4.3L engine the ect (engine coolant temp sensor) would be located next to the thermostat housing.

probably no because Chevy changed the type of fuel injection and it probably operates at a different pressure.

Copyright ยฉ 2021 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.