disconnect negative battery cable rotate the engine in the normal direction of rotation(clockwise)until the no.1 is TDC remove the accessory drivebelt loosen the water pump pulley bolts and then remove the water pump pulley using a chain wrench or a strap wrench to hold the crankshaft pulley,loosen the crank pulley bolt and then remove the pulley bolt and the crank pulley.Make sure that you dont move the No.1 cylinder from TDC while loosening the crank pulley bolt.After removing the crankshaft pulley remove the timing belt retainer/guide flange remove the 4 upper timing belt cover bolts and then remove the upper timing belt cover.Remove the lower timing belt cover bolts make sure that the timing belt camshaft sprocket timing marks are aligned with the top of the cylinder head if your planning to re-use the timing belt put a directional arrow indicating the normal clockwise direction of rotation on the belt remove the timing belt tensioner pulley bolt and then remove the tensioner pulley remove the timing belt remove the timing belt idler pulley bolt and then remove the idler pulley if the camshaft sprocket is damaged or must be removed to replace the camshaft seal or to strip the cylinder head for overhaul use a wrench to hold the cramshaft in place and then remove the sprocket retaining bolt.Then remove the camshaft sprocket from the end of the camshaft remove the crankshaft tioming belt sprocket
Most auto parts stores can get you a wiring diagram for a 1996 Hyundai Elantra. If not in stock, the store can order a diagram for you.
Its should be same thing
how to replace front wheel bearing on 1996 Hyundai elentra
The recommended type of engine oil for a 1996 Hyundai Elantra is 5 W 20. The vehicle will hold approximately 5 quarts of oil.
THe starter/solenoid is bolted to the transaxle bellhousing
Anything made after 1996 I think is OBD2.
you could go to radio shack and get an installation kit for 96' elantra and it is self explanatory.
mine did same, 95 elantra. it was fuse for radio in fuse box. hope that helps.
Under the left front headlight.The headlight has to be removed to access it.
whosale parts warehouse in cali. www.partswarehouse.com
It does not have a belt, it has a chain.
Go to www.hmaservice.com, register and all the cars schematics are there free and a whole lot more
1996 Chevy blazer timing chain
The 1996-2001 Elantra's have two sensors the upstream and downstream the upstream sensor is located the exhaust manifold and the downstream is located behind the catalytic converter.
how do you change a timing belt to a 1996 misubishi eclipse
Yes. 1996 through 2000 Elantras and 1997-2001 Tiburons are basically all the same car, with different skins.Stocker @ RDTiburon.comDavid @ votefordavid.blogspot.com
The timing is computer controled and not adjustable
It is located on the left side off the engine compartment at the fire wall under the brake boster.
Are you having a problem with your timing CHAIN ?
The 1996 Toyota Tacoma does not have a timing chain. It has a timing belt. It will cost approximately $600 to change the timing belt.
5w30 or 10w30 will work. I wouldn't use 10w30 in areas colder than 0*F though.
The 96 Chevy Blazer does not have a timing belt.
how to change timing cover gasket on a 1996 chevy lumina