How do you change the transmission fluid on a 1996 grand voyager?

Answer 1

Place vehicle on ramps to gain acess to underside. Set Park brake and chock rear tires to prevent rolling off ramps. Get a large pan (3-4 gallon capacity) and place under tranny. Remove MOST of pan bolts. Leave one on each corner. loosen lowest two corner bolts. Gently pry pan loose and allow fluid to drain. Remove pan and replace filter. Clean pan (PUT MAGNET BACK WHERE IT WAS IN PAN) then re install using appropriate gasket. Do not over tighten bolts as they can strip out. I believe 14-16 ft lbs torque is correct Please note this will not remove old fluid from torque converter. You must go to a shop and have it flushed for this degree of completion.