The windshield wiper assembly can be removed by unplugging the wiper motor harness, removing the wiper arms and unbolting several bolts that attach the assembly to the firewall. Doing this will give you the room necessary to work on the backside of the engine.
That's a little difficult to answer without knowing what kind of vehicle.
You will need to remove the throttle body and replace the throttle body gasket. The throttle body gasket can be purchased at most auto-parts stores.
The throttle body base gasket would be located between the throttle body and the intake manifold.
You remove the pan, clean the pan, change the filter, install new pan gasket, and fill fluid.
no, with the engine to trans braces removed the pan will come off
No.
Well, if you take off the head,on the engine, you will see the gasket.
I am not sure about the throttle body gasket. I know the flow tube should be replaced. Your problem may be that the flow tube is plugged up with carbon, which is very common with the acura egr system. More then likely there is a reason for the throttle body gasket to be replaced. there could be a link between a vacuum leak and the egr system at the throttle body.
Between the throttle body and the intake manifold.
you get a chiltons manual. then you take it apart and put it back together with new head gasket. quite simple actually. I have the same problem on a 04
Check the throttle body over carefully to find the leak. If a gasket is leaking then a new gasket set will stop the leak. If the body has a crack then you will need to replace the throttle body.
if you do it yourself a lot cheaper than a shop I have repaired 1 caravan head gasket it only cost me roughly $200.00 give or take some $