Just did mine on my 300 cu in Ford 1982. Remove any parts that might be in the way, breather, gas line over the valve cover etc. Remove the bolts around the outside of the valve cover. Remove valve cover. Remove old gasket. Clean valve cover. Install new gasket and re-install cover. Replace bolts. Finger tight bolts first then tighten. If you do not have a torque wrench, carefully tighten down bolts alternating from one side to the other tightening them all down evenly. Do not overtighten, they will snap off into the head.
top of valve engine valve cover // passenger side
Probably a bent valve cover from overtightening Replace or try to straighten then tighten to 10 inch lbs. only
until 1984 the pan gaskets timing cover seal, and valve seals were made of rubber. synthetics will break down the rubber compounds and cause leaks. U can use a synthetic & motor oil blend with less chance of leaks.
There is no PVC valve.... It is a PCV positive crank vent. It should be located near the firewall in one of the valve covers with a vaccum hose attached. to check pull loose from valve cover and pull off vaccum line , then shake it. If it rattles its ok
Well, if its motor oil you're talking about. You should see a cap on one of the valve covers (usually on the driverside valve cover). Take the cap off and pour in. The valve covers sit on cylinder heads. Hope this helps.
The cast of Cover Girls - 1981 includes: Amy Austria Beth Bautista Lorna Tolentino
The cast of Change - 1981 includes: Marcus Kelly
1981-1985
Simon and Simon - 1981 Deep Cover 4-11 was released on: USA: 6 December 1984
40 horses, this was achieved with a three valve head.
Lilydale A Change in Pace - 1981 is rated/received certificates of: Australia:G
The WHOLE engine was BLUE from the factory.