0
you have to replace the wheel bearing hub assembly look up a picture and you will see the bolts are attached to the hub assembly.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
How do you replace a wheel berring on an Oldsmobile regency 98?
how do you replace a wheel bearing on an 1985 oldsmobile regency 98
How do you replace a wheel berring on an 1985 Oldsmobile regency 98?
how do you replace a wheel bearing on an 1985 oldsmobile regency 98
How do you change the harmonic balancer for 1989 ninety eight Oldsmobile regency?
take off the right wheel and the cover wall and you wll see it
How do you change the wheel bearings in a Oldsmobile Alero?
I have changed two of them. Remove the caliper, brake disc and then the large nut at the wheel and then you will have to use a small sledge to pound the the thing that the nut is threaded onto back and then loosen the bolts to the hub
How do you replace the wheel bolts on a 2004 Hyundai accent?
if the bolts do not get on then you just have to change the studs
What is the standard wheel size for a 1992 Oldsmobile 98?
Look on the drivers door jam. Tire size and wheel size should be there. I have a 1992 98 regency and the tire size is P205/70R15. Rim size is 15x6.
How do you change a wheel hub on a Chevrolet optra?
Remove the rear wheel, then the wheel hub should be on four bolts. Remove the bolts and remove the hub. Very easy job.
Do 89 olds regency have steering wheel airbag?
no it does not have a steering wheel
Change a tire on a 1999 Chevy prizm?
to change the wheel and tire on a car just loosen the bolts on the wheel jack it up and replace it
Can you fit 20 inch rims on a 1997 Oldsmobile regency 97?
Yea it will fit,i have a 98 olds regency and i have 20's on it but i had to get air shocks for the back because it will scrap bad without them and a few minor wheel well cut outs u will have to do but its easy,use a dremmel and ur good
How do you change steering wheel 206?
take it to your dealer or service center and tell them to change the steering wheel that's what i did or if you tried that there should be a cap on the front of the wheel and you snap it open and there should be bolts.
How do you change the battery in a 2003 Oldsmobile silhouette?
Ours is a 1997 so this may or may not help. I had to remove the air cleaner assy, the windshield fluid reservoir and then there was a support bracket that ran from the radiator to the wheel well I had to remove. There was two bolts in the front and two that you had to access from the wheel well, once removed you could get to the battery.
