There are 2 screws just inside the bed of the truck that you need to unscrew. The light simply pops out when those are removed. Follow the cable to the plug located near the rear wheel well under the truck and unplug the old light. Run the cable from the new light through and connect it to where the old light was plugged in, screw in the two screws and that's it!
No.... You need to change the whole back tail piece
I was told on 2008 avalanche, should be same on 2007 (not sure) to replace the whole left side valve cover. The PCV is build in in cover ?
You can't you have to replace the whole dashboard instrument cluster assy.
You have to cange the whole light.
u have to pull the whole distributer to change the pickup coil
You have to take the whole light out, there is two screws to take out, then the light will pull out. Then change the bulb. Greeny
you CANT U HAVE TO REPLACE THE WHOLE CLUSTER...
Replace the whole light assembly Their are no bulbs it is neon light
You have to change the whole rearend and the master cylinder.
You can not just change the bulb. You need the whole clock
You don't need to take the whole back panel off to do it!!(learned the hard way) the light cover on the bulb twists out, and it might take some elbow grease to twist it, then the bulb is easy to change.
go to eBay and buy a whole setup for the steering column
If there is no light at all in whole dash. first check the fuse second check the headlight control switch.
hi you unscrew the whole of the light 2/3 with x screwdriver from the outside.
undo the 2 plastic screws at the back of the light the whole light unit comes off then.
Change the whole headlamp bulb. Should be a H4.
pop trunk and locate Phillips head screws right above brake light assembly these screws hold the whole assembly in place.All you got to do is unscrew all Phillips head screws, then the whole brake light assembly folds down, you might have to pry on it a little with a flat tip, then you should be able to get to the tail light from there. Just untwist old bulb then twist new one in.
you cannot fix that you have to purchase the whole thing.
It's a sealed unit with the hub. You have to replace the whole hub assembly.
To replace the brake light bulb you need to remove the whole light assembly. Once removed the change is simple.
there is two rods that go through the housing from the top. turn them to unlock and pull up and out then the whole assembly comes out and you can change the bulbs.
On the inside of the trunk where the light comes through, you'll find 4 big round plastic nuts that you unscrew. The whole light unit comes out once those are removed.
Secret flap in wheel arch under the mud and stuff.
In the '88, you have to remove the whole assembly attached to the trunk lid with 4 plastic wingnut type screws. Go thru the inside of the trunk lid to see them. Have someone catch it as you undo the last nut, it catches you by surprise.