i just took mine out this weekend... theres a bolt at the top going into the fender well metric #10....unhook the upper and lower pumps electrical conectors and the plastic lines....then just pull it up and out....oh...take off the air filter ducting 1st.if the pumps are bad, auto zone has them for $15. each...the lower one is for the front and and the upper is for the rear
Plastic (not melted) is a solid and when it is (melted) is liquid.
chemical change,because the liquid form inside the ice candy plastic,changed into a solid particles and getting iced.
The polydiacethylenes (PDAs) change colour from blue to red when heated
No, the melting of plastic is not a chemical reaction. This is because there is just a temperature change, which happens to change solid to liquid. The solid remains the same element with the same properties, and no "new substance" is formed.
The coin become a liquid by melting; after freezing the liquid change in a solid . But it is possible to destroy some plastic components of the fridge.
Plastic is solid.
because plastic is not liquid so thats why plastic is solid
it is a solid liquid
Yes, the water has turned into ice. It was a liquid but it is now a solid. You can change it back again by melting it.
Yes, liquid has a constant volume. For example, if you tried to squeeze a water filled plastic bag, the water might change shape, but its volume would not decrease or increase.
Discuss six uses of the liquid limit & plastic limit
Soft Plastic Lures are made of liquid plastic that is heated and then cooled to set.
A plastic container will keep a liquid hot longer than a metal container because plastic insulates heat better than metal.
zerozeroConsistency limits and plasticityConsistency varies with the water content of the soil. The consistency of a soil can range from (dry) solid to semi-solid to plastic to liquid (wet). The water contents at which the consistency changes from one state to the next are called consistency limits (or Atterberg limits).Two of these are utilised in the classification of fine soils:Liquid limit (wL) - change of consistency from plastic to liquidPlastic limit (wP) - change of consistency from brittle/crumbly to plasticMeasures of liquid and plastic limit values can be obtained from laboratory tests.
It is a chemical change.
Plastic is not an absorbent material. To the contrary, plastic is waterproof and can be used to make a wide variety of liquid containers.
Sure, change from solid to liquid is a physical change
Gas to liquid change is condensation.Liquid to gas change is evaporation or boiling.
A liquid evaporating is a physical change. Anything changing from a solid to a liquid (or liquid to solid), or from a liquid to gas (or gas to liquid) is a physical change).
Thermosetting plastic has a liquid inside it that is fireproof. Thermosetting plastic can't be melted again.
when ice was solid change liquid because sun was very hot. ice will change liquid change back solid again