see attached link. the thermostat housing is under a throttle body housing. the rear bolt will be hard to get at, not impossible, without removing it. The thread recommended linking 2, 13mm box end wrenches to get enough torque.
Don't forget to bleed it when you are done. Follow the radiator hose to the engine block above the water pump. Should see a housing with a brass bolt. Bring car up to temp and slowly loosen bolt until coolant starts to come out then tighten. DO NOT OVERTORQUE - the head of the brass bolt will snap off. I think there is a 2nd bleed point but can't remember
Where is the computer on a 95 Chevy lumina
completely
you change it very carefully and safety is always an issue
No, the compressors and mounting points are different on the 95 Lumina
BIG JOB Get a manual from DISCOUNTAUTOREPAIRMANUALS.COM
the thermostat will make both fans become idle if it is not opening. this happened to me on my 95 3.1 lumina
Where is the crank sensor on a 95 chevy lumina car ?
Has no carburetor. It is fuel injected.
I need a Diagram for a 1995 Chevy Lumina iginition switch??
Behind the harmonic balancer.
the beretta and lumina motors are about the same i have a lumina motor in my 95 beretta
I need a diagram for vacuum system for a 1995 chev lumina 3.1