Best Answer

read up---in and out... everyone should have a manual for their vehicle, and the library should have a professional manual the reference section, you'll have to make copies of the important sections...good luck :)

2006-07-19 21:48:52
This answer is:
User Avatar

Your Answer


Related Questions

How do you replace a CV joint on a 1992 Chevy pickup?

how do you replace a CV joint on a 1992 Chevy pickup?

Where is the 1992 Chevy 1500 pickup cam shaft sensor located?

1992 Chevy trucks did not have a CAM SENSOR. They had a distributor.

How do you adjust the throttle position sensor on a 1992 Chevy pickup?

You cant

Does a 1992 Chevy pickup have a carbon fiber drive shaft?

Not from the factory, it doesn't.

What size is front ring gear in 1992 Chevy pickup?

The size of the front ring gear in a 1992 Chevy pickup is 7.5 inches. The 7.5-inch ring gear needs a 26 spline axle shaft.

What is the size of 1992 Chevy 1500 pickup front grill?

Please be more specific.

2.8 Chevy 1992 s10 pickup firing order diagram?

Click the link.

If a 1957 Chevy pickup truck body be placed on a 1992 Chevy s-10 blazer?

Not without fabrication.

What is the towing capacity for a 1992 half ton Chevy S10 pickup truck?

how much can a cheve s10 1992 pull ?

How do you change the wiper blades on a 1992 Chevy pickup three-quarter ton?

There are several different blades, Go to the parts store and most will show you how to replace them

Will a 1992 Chevy K1500 cab fit a 1995 Chevy K1500 pickup?

YES, All the cabs are the same from 1988 to 1999

Where is the ecm located in a 1992 Chevy s10 pickup?

Inside the dashboard, to the right of the glove box.

What is the torque spec for the axle nut on a 1992 Chevy Silverado Pickup?

173 FT. LBS.

What is the 5 bolt hole pattern for a 1992 Chevy pickup?

4 x 43/4

What size rims came on a 1992 Chevy k1500 pickup truck?

16 inch rims

Can i put a 1992 Chevy pickup automatic transmisssion into your 1970 Chevy Camero?

You may need to change the length of the driveshaft, move the crossmember back some, and you may need a switch kit for the lock-up converter.

Where is fuel pump on 1992 Chevy pickup?

the fuel pump on a 1992 Chevy pickup is located inside the gas tank but is attached to the top side of it. you have to drop the gas tank to get it out but up want to make sure that there is not much gas in there when you do it because it will be extremely heavy if you don't.

How do you replace the heater core on a 1992 Chevy s10 4.3L truck?

Remove the water supply hoses from your 1992 Chevy S 10 pickup truck heater core. Remove the heater core retaining bolts. Reverse the process to install your new heater core.

In a 1992 Chevy pickup switched from tbi to carb can you switch to an external fuel pump?

um..........i have NO idea

What is the recommended Tire size for 1992 Chevy 1500 pickup truck?


Does a 1992 Chevy s10 pickup have air bags?

No. Air bags were introduced on the 1995 S10 Chevrolets.

How many coils or spark on a 1992 Chevy 305 4x4 pickup replaced cap and pickup coil still no spark?

I would replace the ignition module in the distributor.

Where is the computer in a 1992 Chevy s-10 pickup truck?

under the dash passenger middle ish

In a 1992 Chevy c1500 pickup when should you use automatic overdrive?

When you will be sustaining a speed of over 45 mph

Where is the fuel pump reset button for 1992 s10 Chevy pickup?

There is no fuel pump reset button on that vehicle.