1992 Chevy trucks did not have a CAM SENSOR. They had a distributor.
2010 chevy malibu intake position sensor
It is screewed into the transfur case tail shaft housing. That's for the rear ABS sensor.
The sensor on the 1994 Chevy Caprice is located on the transmission. it is mounted on the tail shaft of the transmission.
There is not 1 on that year. They were NOT used untill 1996
where is the crank shaft pistion sensor located on a 2002 Chevy Malibu, and how hard is it to replace
A 1986 ford van does not a crank shaft position sensor,, it uses the pickup in the distributer
Inside the distributor.
It is located on the back side of the engine, where the distributor originally went.
If it has a 4.3 V-6 it is in the disturber.
The crank shaft sensor on a 2000 Chevy Suburban is located on the bottom of the engine, near the oil filter. It constantly monitors the crank shaft and updates the vehicle's computer of its status.
The TPS sensor is mounted on the throttle shaft on the opposite end of where the cable attaches.
Unplug the electrical connection to the VSS (Vehicle Speed Sensor) located on the drivers side of the tail shaft housing of the transmission. Remove the small bolt and clamp holding VSS in place. Wiggle the sensor out of the housing. Install in reverse order.