your front wheel bearing should be a whole hub assembly instead of the old inner and outter bearing and race..so it comes off when you take the axle nut off..you may need a fourwheel drive socket to fit the nut [auto zone, advance, napa carrys them] the whole thing slides off studs and all..alot sompler than the old way
How do you change a 1998 jimmy 4X4 front wheel bearing ?
36mm
Here is a link to some good instructions. http://reviews.ebay.com/ebaymotors/Chevy-Silverado-4x4-Front-Wheel-Hub-Bearing-Replacement_W0QQugidZ10000000002536494
The torque specs for a 2003 Chevy S10 4x4 wheel bearing is 28 ft. lbs. This is equal to 38 N.m.
How do you replace the front wheel bearings on a nissan frontier 4x4 1999
It is most likely the Wheel Bearing that is going bad.
It will cost approximately $150 to change the front wheel bearing on your 2000 Ford Explorer. The wheel bearing will cost approximately $30 and require two hours of labor to install.
mine was clickin as i turned the wheels and when putting it in 4 wheel drive "electric 4*4" it was a hub bearing goin out
Remove the tire and wheel. Remove the axle end cap. Remove the wheel bearing retaining nut. Remove the axle seal. Remove the wheel bearing. Reverse the process to install the new wheel bearing.
Wheel bearing?
The cost to change a front bearing on a 1999 F250 4x4 will vary from location to location. The average amount of labor for this job would be around 3 hours. Generally most shops charge on average $100 an hour. This would equate to $300 in labor costs.
first take wheel off, remove brake caliper,brake rotor then 4 bolts behind the front wheel bearing assy. then pull front axle out with wheel bearing attached then change u-joint and reassemble. PS wheel bearing assy can be stubborn so plenty of lubricant is needed to break loose