answersLogoWhite

0


Best Answer

petra

pkg unit condnser

fan motor

User Avatar

Wiki User

11y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you check a condenser fan motor on any package unit?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is a packaged HVAC?

Usually a package HVAC or Package unit is one large unit that has the evaporator and condenser in the same location unlike a typical system where the evaporator and condenser are located in separate locations. Package units are usually used for commercial building and placed on rooftops.


If the condenser fan motor goes out and the unit continues what will happen?

overheating of the c.motor and will turn to stop or burn the winding of the compressor motor due to over heating


Where is the AC condenser unit located?

The AC condenser unit is located right in front of the radiator.


What would be a reasonable charge to top up freon on an airconiditioning unit?

Service call freon check it out for clogged condenser $100.00


What would you do if the condenser fan motor smoke out?

First isolate source of smoke- was it the fan motor, wires to it fried or a pinhole leak in radiator going through fan. If the motor is burned out because of bad bearings or whatever you will have to replace the unit.


What are the difference between package unit and split unit?

A package unit contains all elements of the refrigeration cycle in one system. The 4 major components include: A compressor, condenser, metering device, and a evaporator. All elements are needed to complete the cycle of refrigeration. As for a split unit, All elements of the refrigeration cycle are used, however the condenser is located outside of the facility, while the evaporator is located inside of the facility. To better understand the difference in question, you must understand the job of each component in the refrigeration cycle. For example, a condenser is normally used to reject heat or cold air from a building, while a evaporator normally supplies heat or cold air to the building.


What happens when Air conditioner running but fan not turning?

I have to assume that you are referring to the fan on the outside Condenser Unit? The most likely causes are either a burned out fan motor, or a blown Capacitor on the motor startup circuit.


What is an HVAC system condenser unit used for?

To condense


Where is the purge unit located in a low-pressure system?

The purge unit is located at the condenser.


Where is the Rear blower motor resistor 2004 trailblazer?

Check by or near the unit itself


Where is the heater fan relay for a 993 Mercedes Benz 300 e and how do you fix it?

The blower motor control unit is located on the back of the blower motor. 1. Check fuse. 2. Turn on heat and check for voltage at blower motor. Found voltage replace blower. 3. Check for supply power from the fuse on the red wire going to the blower control unit. 4. Check for a good ground on the black wire on the control unit. 5. Check for control power on the yellow wire from the climate control unit. When you select a fan speed (or the unit selects a speed in auto mode) a voltage that ranges from .4 - 9 volts is sent down the yellow wire to the blower motor control unit. 6. If all these checks are good than change the blower motor control unit. Hope this helps.


A single neuron and all the muscle fibers it stimulates comprise a?

This is called a motor unit.