The purge unit is located at the condenser.
After leaving the purge unit in a low-pressure centrifugal system, the refrigerant typically flows back into the evaporator to continue the cooling cycle. This helps maintain the balance of refrigerant throughout the system and ensures efficient operation.
The base unit of Temperature is Kelvin (K)
yes The Kelvin scale is a way of measuring temperature from absolute zero. The gradient is the same as the Celsius (or Centigrade) scale. Not actually a unit of heat, just a measurement of temperature.
A liquid dilution system which dilutes a sample to be analyzed with a carrier to supply a diluted sample-containing liquid to an analytical measurement apparatus of flow type. The inventive dilution system features simplicity and versatility as compared to conventional automatic apparatus with robot concept, and the present system comprises: a first carrier pump for feeding a first carrier; a sample injection unit for injecting the sample into the first carrier; a main passage for flowing a liquid from the sample injection unit to a detector unit of an analytical measurement apparatus; a branching device located downstream of the sample injection unit for forming a branched passage to remove a liquid mass partially from the main passage; a confluence unit located downstream of the branching unit for confluencing a second carrier; and a second carrier pump for feeding the second carrier to the confluence unit. Dilution and mixing of the sample with a carrier is done twice, once at the sample injection and then again at confluence.
The unit of measurement for pressure is the pascal (Pa) in the International System of Units (SI). Other common units for pressure include atmospheres (atm), pounds per square inch (psi), and millimeters of mercury (mmHg).
These are located in the system unit or processing unit.
condenser
serial-unit numbering
After leaving the purge unit in a low-pressure centrifugal system, the refrigerant typically flows back into the evaporator to continue the cooling cycle. This helps maintain the balance of refrigerant throughout the system and ensures efficient operation.
The purge valve on the '96 626 is located on the passenger side of the engine. It bolts onto the intake manifold. There are 3 valves that make up this unit and all three are bolted on as one piece. Hope this helps. You can go to any auto parts website and search for purge valve and it will show you what it looks like.
leave purge unit on at all times
System unit
In w203 it's located in the trunk. SAM control unit.
Converter
Inside the heater/ac unit close to the main unit.
The condensing type of this air conditioning unit is a split system, where the condenser unit is located outside the building.
ROM is Attached to the mother board inside the system unit.