Amperage is measured by a multimeter. First determine the amperage rating on the multimeter. Next, select the appropriate setting on the tool. The next step is to set the range on the multimeter. Make sure to plug the leads into the appropriate terminals. Run the circuit through the multimeter to measure the current. Turn off the breaker, make sure the AC circuit is turned off, then rewire the circuit.
you dont you need an ammeter for that
As your static pressure increases your Amp draw will drop
You may have a loose wire somewhere. You need to check the amp draw of the unit.
You would need to put an amp-meter on the circuit to see what the current draw is like. ====== If the compressor is shorted to ground you cannot check the amp draw because it will constantly kill the circuit breaker. A better way to go would be to check the continuity of the compressor to ground and each winding.
check the amp draw , maybe drawing too much amp for some reason , only way u could draw more ampe is when u have more load on the head light circuit
If you draw one amp of power for 1 hour that is an amp hour . If you have a different load eg a heater drawing 3 amp , it would be 20 minutes . Divide the hour ( 60 mintues ) by the amps you draw .
Total battery amp hours of the battery, divided by the amp draw, equals the life of the battery.Example=200 amp hours, divided by 5 amps, equals 40.00 hours.There are many different factors. This is based on constant draw.
Possibly, most 230 volt saws draw about 16-18 amps on each line. There will be a spec plate on or by the motor which has the amp draw marked. CHECK this first.
the D stands for draw version of the amp drivers
Should be under .035 amp
2 amps
1 AMP