0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Why is the wheel tipped out on the top side of a 1992 chev 4x4?
Need to check the upper ball joints first.
How much does it cost to replace the ball joints on a 99 Chevy blazer?
$1200
Where are the grease fittings on a chev blazer 4x4?
Not all vehicles have grease fittings but in the event it does you will have one on almost every moving front end part such as upper and lower ball joints( driver and passenger side ) idle arm ect.
How do you replace lower ball joints on a 2000 S10 blazer?
first you take it in then pay them to do them for you!!!!!!!!!!
Will you need a press for 97 blazer ball joint removal?
Im basing this answer off my 97 blazer ls 4wd. Both upper and lower ball joints are bolt on so u will need to remove the bolts and the ball joints should fall right off.
Where do you lube a 1996 Dodge stratus?
Check upper ball joints and outer tie rods.Check upper ball joints and outer tie rods.
How do you replace ball joints on 98 Chevy blazer LT?
Remove the tire and wheel from your 1998 Chevrolet blazer. Remove the ball joint nut. Pound the ball joint out with a hammer. Reverse the process to install the new ball joint.
Where are the grease fitting on a 2000 dodge ram 1500?
Check tie rods, ball joints, trac bar, and u-joints.Check tie rods, ball joints, trac bar, and u-joints.
Noise coming from driver side wheel 2000's10 blazer brake pads are good?
Check the wheel bearing. Make sure it is full of grease. Check the tie rod ends and ball joints as well.
How do you replace the ball joints on a 1995 ford F150 4x4?
Replacing Ball joints Check Related Links Below
How do you change the lower left ball joint on a 92 chev s10 blazer 4x4?
Remove the tire and wheel from your 1992 Chevrolet S 10 Blazer. Removing the brake assembly and the brake rotor will give you more room to work. Remove the ball joint nut. Pound the ball joint out with a hammer. Reverse the process to install the new ball joint.
How long should the lower ball joints last on a 98 Chevy blazer can't get more than a year out of a set?
YOU CAN GET A FEW YEARS OUT OF A SET OF BALL JOINTS, BUT THEY WILL NEED TO BE GREASED REGULARLY. USUALLY YOU WOULD HAVE THEM GREASED AT THE SAME TIME AS YOU HAVE YOU CAR SERVICED(OIL CHANGE ECT). A NEW SET OF BALL JOINTS MUST BE INSTALLED CORRECTLY USING THE PROPER TOOLS OR BY A PROFESSIONAL. SOME MANUFACTURERS OF AFTER MARKET PARTS HAVE POOR QUALITY PARTS AND THEY DO NOT LAST AS LONG AS THE ORIGINAL MANUFACTURERS PARTS DO. MY FATHRE HAD A SIMILAR PROBLEM WITH HIS CHEV SUBURBAN. WE HAD TO REPLACE THE BOTTOM BALL JOINTS A SECOND TIME WHEN WE HAD ONLY A REPLACED THEM A YEAR BEFORE. LUCKLIY FOR US THE MANUFACTURER OF THE AFTER MARKET PARTS HAD A WARRNTY ON THE BALLJOINTS AND WE HAD THE PARTS REPLACED WITH A NEW SET FREE. YOU MAY WANT TO CHECK WITH THE PART SUPPLIER YOU PURCHASED YOUR PARTS FROM TO SEE IF ANY WARRANTIES APPLY.
