0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Where is the heater blowing cold air on 2006 Chevrolet equinox?
A common cause is a broken temperature door in the dash. Very big repair job. See CHEVY EQUINOX and PONTIAC TORRENT no heat below... --------------------- Heat blend door. Yes a VERY expensive repair and it is becoming quite the popular problem in 2006 equinox but Chevrolet will not do anything about it. www.topix.com chevroletforum.com www.web2carz.com websites I have found where people have complained about the air blend door. First off the Chevrolet dealer wants you to come in and pay ($85 at our dealership) to get the problem "diagnosed" (even though I told him what the problem was) then the cost to fix it ranges from just over $1,000 to $1,500 because they basically have to remove the entire dash to get to the air blend door only to replace it with another inferior product.
Why does the blend door actuator make the clicking noise?
Probibly your blend door motor is stripped out. Remove motor and check door operation manually
What would be wrong if heater and ac dont work and its not heater core?
First check the fuses then check your blower fan then check the blend door and blend door actuator and then the control panel
You only have heat working on your 1998 mark?
Check your blend door.
How difficult is it to replace the blend door on a 2007 Chevy Equinox?
You have to take the front dash apart almost to the firewall. A lot of 5,8and 10mm screws. Not a job for a DIY'er.
Where is and how do I check Blend door on my dodge ram 1996?
The blend door actuator motor is located on the bottom of the plenum box on the passenger side towards the transmission tunnel. It is easy to remove and examine the motor to blend door connection. The blend door on the Ram is made of metal and seldom breaks. The problem is more likely the plastic interposer that spans between the metal drive motor connection the the metal axle. Check Ebay listings for HeaterTreater to find the Ram and a 100% solution and more diagnostic information.
How do you repair the blend door in the heater on a 1999 Ford Windstar?
The blend door is vacuum controlled. Any vacuum leak in the engine system can cause the door to not function properly. Check this system first. The door could be physically sticking but a vacuum leak is a more common problem.
How do you change a blend door actuator on a 2000 ford windstar van?
Before replacing the thermostat or any other component of the Windstar's HVAC system, be sure to check your blend door for functionality FIRST. The most common issue with heat or A/C in the late model Ford windstar is a broken blend door. A broken blend door actuator is almost as common as a broken blend door itself. Typically, the fix requires disassembling the entire dash and replacing the whole plenum box, which can be a costly repair.
How to repair the blend door in the heater on a 2005 Ford Explorer?
I do not have heat in the car and the blend door clicks. How do I access the blend door in a 2005 Ford Explorer?
What would cause a 2000 Blazer not to change from ac to heat?
The most common problem causing a 2000 Blazer to stay on heat is a problem with the blend door. Check the blend door and its control circuit to fix the problem.
Why is the heat not working on your 5.3L 1999 silverrado Pickup 4x4?
Sounds like your blend door may be broken. the blend door opens and closes on the heater core to allow heat into the cab by letting the air blow over the heater core. The heater core basically looks like a small radiator and when the blend door gets opened up, it allows to air from the blower motor to blow through the heater core fins and that heats the air before it is pushed out the vents into the cab... Check out www.heatertreater.net Those guys have videos on there of what I am talking about. It may not be your blend door though. Could also be the blend door motor or the dial to turn from cold to hot... I would check that blend door first though...
Why is it on a 1997 ford f'150 only hot air no matter what the controls are set on and only air out of the defrost?
Check the blend door under the dash on the F150. Check the vacuum system as well. The vacuum controls the blend door and controls the heat as well as air from the defrost.
