a trans pressure shoul do
all of the components for the top, including a plug in the side of the motor to fill with fluid from are under the back seat area. Refill for fluid is dex trans fluid.
Check hydraulic fluid level Fill with pistons in retracted position
under spare wheel in the boot
Pneumatic pressure testing of pressure vessels is done to check the leakage for any leakage where as hydraulic pressure testing is done to check the vessel for its strength.
A list of Preventive Maintenance Task for a Hydraulic System could be: Change the (could be the return or pressure filter) hydraulic filter. Obtain a hydraulic fluid sample. Filter hydraulic fluid. Check hydraulic actuators. Clean the inside of a hydraulic reservoir. Clean the outside of a hydraulic reservoir.
check out www.championrescuetools.com, they are just a hydraulic cylinder able to work under high pressure
Hydraulic or mechanical? If hydraulic Check fluid level Check operation of Master and Slave cylinders Check operation of throw-out bearing Check operation of pressure plate If mechanical: Check pedal to see if linkage disconnected or broken Check pressure plate and throw-out bearing
Hydraulic pumps do not develop pressure. Pumps can only develop flow. To obtain pressure in an hydraulic system, restriction to flow must be introduced. In order to control pressure, pressure relief valves are used. These valves, simply put, employ spring pressure acting on a check ball that resists the flow of oil. Most pressure relief valves are adjustable within a given range so that system pressure is also adjustable.
Check your hydraulic clutch reservoir to make sure it is full, if it is, it may be bad and need to replace.
Not Sure
The pump is located in the trunk behind the back seat. You will need to place some rags to collect the hydraulic fluid. Disconnect the lines and the mounting and replace the pump. Before you do all of that you need to check and be sure that you have power and a good ground to the pump.
check the VIN