0
Remove from engine and use an ohm meter on the ends
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
I need A copy of the wiring diagram for the transistor distributor option on a 1966 Chevelle 396ci 360hp engine?
try to get a chiltons repair manual at the library for 66 chevy's or check with your local chevy dealer to see if they have any info on it.
What do you do if timing and distributor are set but engine still backfires 1989 Chevy 305?
maybe check for a worn CAM LOB.
Will a 1994 Chevy suburban engine wiring harness fit a 1993 Chevy k1500 engine wiring harness?
If the motor is the same the wiring harness should fit. Only thing I would check is the sending units. As long as both vehicles have gauges or both have warning lights all should be fine.
Can you switch from tbi back to a carb and regular hei distributor on a 87 Chevy 350?
yes, but check engine will probably come on and stay on
Distributor and coil problem on a 72 Chevy caprice 400 small block engine no fire?
Check out your control module under your distribtor cap.
How do you set timing 1998 Chevy 1500 5.7?
You can't, it is not adjustable, The timing is controled by the computer and there is no reason to mess with the timing. Now if you Have had the distributor out and put it back in and the engine will run and it has no check engine light on then you got lucky. Now if the light is on then you will have to get an OBD2 engine scanner and then go into the timing mode and move the distributor until you get cam and crank in time and the check engine light will go off. Tighten distributor and the computer will do the rest.
When you try to start engine there is no spark in 1991 Chevy silverado?
Need to replace ingnition module in the distributor. First check coil and coil wire, And when your in the distributor make sure you check the two electric wires that go to the pick-up coil in the center of the distributor, make sure there not broken ( PULL ON THEM A LITTLE ) Need to check these things first.
What is the ignition timing on a 1986 Chevy Blazer?
It should be 6 degrees before tdc, just make sure you disconnect the distributor's computer control wiring harness before you adjust, and check the timing with a timing gun.
No spark 1995 Chevy 2500 truck?
Check the module under the distributor cap.
What would cause a ecm b fuse on a 2000 gmc sierra to continually blow?
on gmc's and chevy's there is a spot in the wiring harness that goes down the back of the engine block on the passenger side next to the distributor, this section of harness continuously rubs on the back of the block, more so if an intake manifold gasket was just replaced. it will rub a hole in the wiring loom and ground out there. check it out and see.
How do you reset check engine light for the 2009 Chevy trail blazer?
How do you reset check engine light for the 2009 Chevy trail blazer?
1994 Chevy k1500 no spark no fuel?
Need to check or replace the ingnition module in the Distributor.
