The first thing when you start to clean carburetor is, you need to soak it in solvent to get it cleaned. The more stronger the solvent is, the better cleaned can be your carburetor. You can get these cleaners at the automobile supply stores. Make sure you have a pair of hand gloves since the cleaners are very strong, so avoid touching with bare hands.
next, once you have finished soaking the carburetor, you can then remove it from the solvent and wipe it off. Don't forget to wear your gloves while doing it. While cleaning, you should make very sure that it is wiped properly since a little solvent lft can damage your bare hands later. The final step of the cleaning process is to use an air compressor to blow through the interior of the carburetor. This blows the inside dirt free after the solvent has loosened it.
The carbuerator advances the distributer.
It's fuel injected and has no carburetor. Use a quality fuel injector cleaner such as Seafoam or Techron poured into the fuel tank every 6 months to keep the injectors clean.
You don't have a carbuerator on that Diesel - they are fuel-injected.
there should be a screw in the side of the carbuerator. turn the screw all the way in be careful not to bottom it out tight you will ruin the needle valve. then turn the screw opposite 1 1/4 times this should be good slow idle and also fast idle speed.
There is a little nut on the top of the carbuerator that you turn. Play with it and see how you get the best results
A 1997 Ford Crown Victoria engine is fuel injected so there is no carburetor
This could be a number of problems... Fuel pump problem? Carbuerator / fuel injection problem? Timing problem?
what size is the original tires on a 1986 goldwing? what size is the original tires on a 1986 goldwing?
Basically, it mixes gas and air and pushes into the cylinders to ingnite and cause an explosion pushing the pistons down, and turning the crankshaft.
how about plugs, wires or ignition module
The only butterfly valve I am aware of is in the carbuerator and contols air flow. Few cans still use this item.
vacuum advance can connect anywhere there is vacuum present,carbuerator base is a good spot