0
You can use some carb cleaner, spray it on a rag and wipe it clean
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
What is the problem with your Isuzu rodeo if it stays idled up?
EGR or Mass air flow sensor
Got a code P0401 Isuzu Rodeo what is the cause?
Trouble code P0401 means:Exhaust gas recirculation flow insufficient detected
How do you check on my 1998 Isuzu Rodeo transmission oil?
Unfortunately you do it with difficulty. Isuzu maliciously decided not to have a transmission dipstick on the transmission so the average guy cannot check it easily. Per the book, the transmission must be warmed to a precise temperature and then an overflow plug on the transmission is taken out. Fluid is added until it starts to flow out of the overflow plug and then you know it is full. it obviously must be done from under the vehicle. I would not have bought mine had I known this.
What does Diagnostic code P0402 and P1404 mean on a 2000 Isuzu Rodeo?
P0402, excessive EGR flow P1404, EGR range performance, valve closed Most of the time I find the EGR port in intake clogged. If you look in throttle body you will see a 3/8 tube plugged with soot. Clean and reset with scan tool.
How do you clean Mass air flow sensor on a 1998 Nissan Altima?
how do you clean mass air flow sensor on a 1998 Nissan altima? To clean the mass air flow sensor , you need to get a can of CRC mass air flow cleaener frm auto zone, Kragen, Pepboys, Sensor is attached to the tube (next to airfilter). again you need to use mass air flow cleaner ( CRC ). I use this on my ford windstar and Nissan sentra 05 and 95. it runs better after cleaning the mass air flow sensor.
Is there a kit available to add a dipstick to a 1999 Isuzu Rodeo automatic?
no there is no kit. to check the fluid the truck must be level,warm and running. remove the top plug on the pan (which is on the pass. side)and fluid should flow out. its not easy.
Where is the egr valve located on 1998 Isuzu Rodeo and how can you correct EGR flow insufficient?
It is located on the left side back for the engine looking from the front. Once u find it remove the two bolts and pull upward. Remove the gasget and use Carb cleaner to remove all the carbon deposits inside the EGR valve. This worked for me and i saved 110 dollars by not replaceing it. Works just like new.
How do you change the fuel filter on a Isuzu Rodeo?
Fuel filter is on frame rail next to the fuel tank. Undo clamps and change, pointing the arrow in the flow direction. If you have the spring type clamps then it's a good time to put screw type on. The manual says to disconnect the battery first for safety.
Where is the mass air flow located on a 2000 Isuzu Rodeo?
M.A.S. ;99 Rodeo.I own a '99 Isuzu rodeo, so this may not be exactly it, but should be close. My mass airlfow sensor is located between the filter and the throttle body. It is inline with the intake hose. This is in my experience the typical location for it. Itlooks like a ring around the intake hose with a box maybe 3"x3"x1" with a wire attached to it. Usually, if you detach the hose from the filter box, and look into the hose, you'll see a mesh grating. This protects the sensor from any debris in case anything were to get past the filter.If you're very careful, sometimes you can clean the sensor elements and avoid replacing the sensor. Remove the sensor, remove the mesh and spray with a cleaner that leaves no residue (brake cleaner is good-- not carb cleaner) if necessary, gently wipe the sensor elements. They are fragile.
What does code p0102 mean on 1999 Isuzu amigo?
Trouble code P0102 means: Mass air flow or volume air flow circuit low input
How do you change the idle speed on a 1998 dodge grand caravan?
the idle is controled by the computer you can set minimum air flow but have to have a scan tool if it is idling to low clean the throttle body of carbon
Where is the thermostat located on a 2000 Isuzu trooper?
The thermostat on a 2000 Isuzu Trooper is located on top of the engine, below the upper radiator hose. It controls the flow of coolant to the radiator and throughout the vehicle.
