On a saw without limiters, turn them in, counting the turns, until lightly seated and then back out the same number of turns. If it has limiters, they will need to be removed. That will usually clear the jets.
Yes
You can't adjust valves, all you can do is clean or replace them.
you can but you can't be sure if the needle is clean. also the correct needles to use, are hollow, a sewing needle will tear the skin and also be very hard to put through your year. you need to use a sterilized hollow needle. you can try to clean the needle but just take about 5$ and order a hollow needle online. ------------------------------------------------------------------------------------------- although it may not be recomended, they work just as well if you're doing your own. i use them for the peircings i do myself, and i haven't had any infections. just be sure the needle is clean before you use it.
pressure test it to see if valves are working, and check diaphragm for holes Just pick up a rebuild kit for it...clean it up real well when its tore apart...then re-intsall it. If it still doesnt work then its new carb time
wire wheeling the valves is the best way but scotch bright works good to.
Clean the jets in the carb. When you use the choke is sends gas in through another port.
no aslong as being used with a clean bar and needle.
If a clean needle is used (That hasn't been use before) no
You can't. You get it from the needle not the tatoo.
Because the detergent reduces the surface tension of the water.
Find a vain use a clean needle go in at a angle.
In some cases, a needle junkie can be legally mandated into rehab through court-ordered treatment or intervention programs. This often occurs when the individual's substance use poses a significant danger to themselves or others, and they may not have the capacity to seek help on their own.