yes
just bleed your brakes through each wheel cylinder until the fluid runs clean
Wheel cylinder stops would keep the wheel cylinder from coming apart.
Ovality and Taper Guages are used
Sounds like a wheel cylinder problem.
If a pressure type brake fluid dispenser is available attach it to the top of the master cylinder. Other wise fill the master cylinder, start with the wheel cylinder that is furthermost from the master, and bleed until fluid comes out clean and free from bubbles. make sure to replenish the the master cylinder as needed. then proceed to the next farther wheel cylinder and repeat with the rest of the wheel cylinders. top off the master cylinder. Test with the engine off then with the engine running before driving.
Brake wheel cylinder or axle sealBrake wheel cylinder or axle seal
take the brake line out of the back of the wheel cylinder, pull the brake pads off and then take the 2 bolts out of the back of the cylinder and pull the wheel cylinder out.
Rear wheel? Remove wheel Remove brake drum Loosen and remove brake line to wheel cylinder Remove mounting bolts at rear of wheel cylinder Pry brake shoes back from wheel cylinder Pull wheel cylinder off backing plate Install in reverse procedure Bleed affected brake line
The peugout 406 deos not have liners, the bores are cut directly into the cylinder block
take tire off, pull brake shoes off, and on the backing plate in the back of it you will see 2 bolts that hold the wheel cylinder on, take the brake line out of the wheel cylinder and remove the 2 bolts and the wheel cylinder is off.
A wheel cylinder describes "Drum Brakes" - Drum brakes have one cylinder with two diametrically opposed pistons.