Honda Accord
Honda Accord EX
Honda Accord LX

How do you drain the master cylinder on a 1993 Honda Accord?


Top Answer
User Avatar
Wiki User
2015-07-15 21:11:15
2015-07-15 21:11:15

just bleed your brakes through each wheel cylinder until the fluid runs clean


Related Questions

A couple ways. Use a turkey baster. Open the bleeders and allow it to gravity bleed.

The oil drain plug is located on the bottom of the engine screwed into the oil pan.

where is the coolant drain plug on the engine block of Honda ACCORD 2.4 2006

The 1999 Honda Accord air conditioning drain to can be located on the bottom of the air conditioner compressor. The drain to allows condensation to drain on the ground below the engine.

The correct tightening torque for a 1990 Honda Accord oil drain plug is 29 foot pounds. This same torque applies to all Honda oil drain plugs.

Drain plug on bottom of oil pan.

out the petcock on the back side of the radiator

The radiator drain plug on a 1988 Honda Accord LX is located on the lower right side of the radiator. If facing the vehicle from the front, it would be on the driver's side of the radiator. To drain easily, loosen the radiator cap after opening the drain plug.

Bottom of the engine on the oil pan.

Remove the oil pan drain plug to drain the oil. Remove the lower radiator hose to drain the coolant.

Open the drain screw at the bottom of the gearbox hydraulic fluid is discharged.

The Coolant Drain Plug for a 1997 Honda Accord LX 4cyl is at the bottom of the Radiator on the left side, if you were facing the Vechiel. It if stock it looks like a Black Medal Wingnut, unless different Drain Plug was put in by previous Owner. The block drain is an 8mm plug next to the oil filer on a 94 Accord LX 2.2L. 94-97 might be the same. There is a 10mm plug near the oil filter also, but it contains oil... I know. I have tried to remove my coolant block drain plug but without success so far... It is torqued! hw

its in the pasenger side on the oil pan,

NO, you must pump fuel out with a hand pump.

From the transmission bolt ,with the square cut out in it Just be careful

I recommend only Honda genuine Z1. About 3.5 quarts on a drain and fill

It is on the rear of the engine block above the drain plug.

In the down panel from back. Its like a butterfly

you pull the drain plug on the side of the transmission

Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.