disconnect battery for one mi.
Auto Zone will check your engine codes and if you ask they will clear your codes for FREE.
Clear all PCM codes.
Are you asking how to clear engine trouble codes? You'll need a code scanner with a reset/erase feature.
If the check engine light stays on for the Nissan Pulsar n16, you would need to check the engine in order to clear codes. You can take the car for service and the problem will be diagnosed and restored to normalcy.
pretty much instantly. As soon as the codes are cleared the check engine light goes off and vice versa, unless there still is trouble. In this case the codes won't clear until the trouble is repaired.
Fix the cause of the codes, and clear the codes with a scanner or by unhooking the battery.
After reading the codes, and repairing them, you clear the codes with a scan tool.
You can disconnect the battery for about 5 minutes and this will clear the check engine codes stored in the computer. If the problem that caused the code has not been repaired the check engine code will just happen again. The only way to get the check engine light to not be on is to repair the problem then clear the codes.
Sometimes simply disconnecting the battery will clear codes, or after cycling through the start mode so many times will do it .You can also plug an O.B.D. unit into your E.M.C. as a code reader and clear codes. Pull the fuse for the ecm.
Either try disconnecting the battery for about 10 minutes or have vehicle scanned to determine problem and clear codes
No.....its against the law to clear codes.
Have the codes read, repair the cause, clear code with a scan tool or battery disconnect.Have the codes read, repair the cause, clear code with a scan tool or battery disconnect.