The best way to do it is to identify and correct the issue which is causing the MIL to illuminate. Otherwise, it will simply come back on the next time the deficiency is detected. If you know it's a single count DTC which isn't self clearing, and don't have an OBD scan tool to clear it with, disconnect the negative wire from the battery for 1/2 hour to an hour.
The check engine light is reset with a scan tool after repairing the failure that caused the engine computer to set a trouble code.
How do you reset engine light on jeep liberty diesel
The engine computer controls the check engine light.
Trying to clear the check engine light in a Kia Sorento yourself is not recommended. The check engine light could indicate a serious problem and the car should be inspected by someone qualified.
I clear the check engine light with a Scangauge II. But most ODB-II devices can read and clear the code.
what is this code p1491 on 2003 jeep liberty
A scan tool is required to clear the check engine light. If the failure is not repaired, the light will return.
There isn't a single fuse for the check engine light. See related questions for explanations of why the light comes on and how to clear it.
Unhooking a battery doesn't clear the codes on a 2003 Jeep. You need a scan tool.
If the check engine light stays on for the Nissan Pulsar n16, you would need to check the engine in order to clear codes. You can take the car for service and the problem will be diagnosed and restored to normalcy.
No, a person cannot just clean a check engine light to pass inspection. The issue causing the check engine light must be dealt with and fixed.
The check engine light is reset with a scan tool after repairing the failure that caused the code.
Scan tool, will give you a trouble code as to why the computer turned the check engine light on.