Turn the ignition to the on position, the depress the gas pedal fully three times. The oil light should blink, the turn the ignition off for a few seconds. Start the truck and you should be good to go.
You need to rent / purchase an OBD II code reader to check & reset the check engine light.
Trying to clear the check engine light in a Kia Sorento yourself is not recommended. The check engine light could indicate a serious problem and the car should be inspected by someone qualified.
The Check Engine light is on because there is a problem with the emissions system. Once you have the problem repaired the light will go off.
Usually repairing the problem will allow the computer to clear the code. Use an OBD2 code scanner to read the diagnostic code and get an idea of what to do to repair the engine.
I clear the check engine light with a Scangauge II. But most ODB-II devices can read and clear the code.
A scan tool is required to clear the check engine light. If the failure is not repaired, the light will return.
Have vehicle scanned to determine the problem and clear codes
Have vehicle scanned to have stored codes erased
There isn't a single fuse for the check engine light. See related questions for explanations of why the light comes on and how to clear it.
If the check engine light stays on for the Nissan Pulsar n16, you would need to check the engine in order to clear codes. You can take the car for service and the problem will be diagnosed and restored to normalcy.
No, a person cannot just clean a check engine light to pass inspection. The issue causing the check engine light must be dealt with and fixed.
A person can reset the check engine light by using an OBD scanner to clear the codes. This is after the problem is fixed.