To bleed the clutch:
-With the bleeder valve closed, depress the clutch pedal to the floor.
-Slip your foot off the pedal and let it fly back to the top (DON'T be gentle).
-Repeat several times (5 is a good number)
-Depress the pedal to the floor, hold it there, and have a helper open the bleeder valve on the slave cylinder.
-Allow the fluid to run out.
-When the fluid stops flowing from the valve, shut the valve and release the pedal. Repeat as needed.
-Be sure to keep the reservoir full, a third person to watch the reservoir is a very good asset to have.
A 1990 Ford Ranger may not shift into gear if the clutch is out. A clutch can be purchased at any auto parts store.
how to i change a clutch in a 1993 ford ranger
how do I bleed the clutch system in a 2004 ford ranger
How to replace a clutch interlock switch on a 1997 Ford Ranger XLT
inside the hood on the driver side fire wall near the master cylinder
DOT ( 3 ) brake fluid is used for the hydraulic clutch in a Ford Ranger
A 1990 Ford Ranger is OBD I / EEC IV - if that's what you are asking
location of fusable links Ford Ranger 1990 2.9
you have to have fan clutch wrenches
spark plug gap on 1990 ford ranger 4.0?
is there a picture of where the horn fuse is located on a 1990 ford ranger
changing clutch in 1994 ford ranger ===================================================================== If it is like the ( 1996 ) Ford Ranger The clutch fluid reservoir is in the engine compartment , it is between the Power Distribution Box and the drivers side fender , It takes DOT 3 brake fluid