0
How do you configure the spark plug wires on a big block Chevrolet distributor?
Wiki User
∙ 18y ago
1-8-4-3-6-5-7-2 is your firing order, same as small blocks. from the factory number one wire should go to the tower on the distributor facing number 1 cylinder. that would be the front cylinder on the drivers side. from there hook up number eight clockwise right next to it, then number 4..3..6..5..7..2.
Wiki User
∙ 18y ago
Add your answer:
Earn +20 pts
What is the spark plug gap on a 1969 Chevrolet Camero with a 5.7 motor?
If it has points in the distributor then it is 0.035 If it has an HEI distributor then it is 0.045
Do you need to do the timing after changing the spark plugs?
no the plugs just delivers the spark. you only need to do timing if u pull the distributor out of the block or do a timingChan or if the distributor slips
What is the spark plug gap for a 1986 454 big block Chevrolet engine?
.045
Where is distributor located on 1995 z28 lt1?
It uses the Opti-Spark distributor which is flat, its located between the water pump and engine block.
Chevrolet lumma van 93 what would cause it to not have any spark?
Check pick up coil on distributor
What is the firing order for a 1997 Chevrolet suburban 5.7l v8?
firing order from spark plug to the distributor cap
Where the distributor on a 1994 Chevy sliverado 1500?
it should be right behind T.B.I unit....just follow your spark plug wires from block to..distributor and there it is....
What if there is no spark on a 1993 Chevrolet S10 the coil is good?
start with checking the fuses, coil wire, distributor cap and rotor.
Where on the vehicle can you find the spark plugs?
Find the coil pack or distributor on the vehicle and follow the wires from there to the engine block.
How do you know if the pick up module is out?
You will have no spark from the distributor.You will have no spark from the distributor.
How would you test a spark plug?
On a carburetors motor pull the coil wire from the distributor cap (the plug wire in the center of the distributor). This is usually found between the air cleaner and the firewall. Remove the desired spark plug from the engine block, plug it into the coil wire and touch the spark plug body (the metal portion) to the engine block while cranking the engine. You will see spark if the plug is good.
Where can I get a spark plug diagram for 1975 corvette HEI distributor?
The firing order on all Chevrolet engines is 1,8,4,3,6,5,7,2. 1,3,5,7 are the left bank and 2,4,6,8 is the right bank and the distributor turns clockwise.
