It is important to only connect the oven range cord to the unit when the wires are color-coded. This is because if these wires are not correctly connected they may lead to the destruction of the oven.
How do the wires connect on a 3 prong electrical cord on the lde8414ace maytag dryer
Connect to two wires you have to the the spade connectors and forget the ground connector. The spade connector wires should be black and white. Black to gold and white to silver. If the wires coming from the heater happen to be red and white, then red goes to black. You could buy a simple lamp cord which has only tow wires.
You use a known ground and check them for voltage. You can use an extension cord to reach from a ground to the wires you are testing. You are not putting it in an outlet, just to connect you to a ground.
No, not by itself. The cord should be replaced. If that is impractical, an electrician can cut out the melted part, connect the wires back together, then tape the wires and then the cord around the repair. This fix is pretty safe and secure.
A patch cable or patch cord connects one electronic devise to another. By using a patch cable, or patch cord, works by inserting one end into one device, and the other end into another. The wires in the cord will connect the two devices.
You have to connect it with a ethernet cord ... the cord looks like a phone cord but the tip (head) is much fatter...
First off, it is not a 3-phase range. It is a single phase 110/220V range with a cord lacking a ground pin. Also, it is not a 4 phase outlet. It is a modern 110/220V outlet with a ground pin. To upgrade your range, go th the hardware store and buy a new 4-prong 50A 110/220V cord with a ground. Remove the old cord, and wire in the new cord. If the old cord was flat without a color code, the two outside wires are the hots (red and black on the new cord) and the center wire is neutral (white on the new cord). If the neurtal lug is bonded to the chassis, break the bond. The green wire in the new cord grounds the chassis. Connect the green wire to a convient screw in the chassis, if a dedicated green ground screw is not provided.
To connect a three prong power cord to a stove, remove the back of the stove and take off the old cord using a screwdriver. Connect the new cord according to the wire colors with the screwdriver.
You use the cord that came with your iPod and connect the cord to your iPod and computer
This may be happening because some of your cords are not fully plugged in. Check the cords that connect that ps2 to the television and make sure that they are plugged in well. It's the cord that has three wires.. the tips of the wires are yellow, white and red. The red is the cord that controls the volume. So I am guessing that your white and yellow cord are plugged in while the red is not fully plugged in.
When flexible cords are talked about the ground wire is in the conductor count. A four wire cord will have black, red, white, and green coloured wires in the flexible cable set. A three wire cord will have a black, white and green coloured wires in the cable set. To use a four wire cord to carry 220 volts just use the black, red and green wires. Connect to the cord ends. Black and red to the outside blade terminal screws and the green wire to the green ground screw. To use a three wire cord to carry 220 volts just use all of the wires. Black and white to the outside blade terminal screws and the green wire to the green ground screw.
To answer this question correctly the number of wires in the existing cord is needed.