Want this question answered?
The ends connect to the spool that's driven by the motor.Once that come off the track or break, you cannot repair them. You must replace the entire regulator.Here's how:http://www.ricksfreeautorepairadvice.com/repair-topics/window-power-repair/replace-a-power-window-regulator
To fix a cable on an electric window on a 2004 Chevy Epica you need to first gain access to the wire by removing the door panel. From there, you can either fix or replace the cable.
A rear electric window that has jammed on a Renault Megane Dynamique might be termed off cable. This means that the mechanism for raising and lowering the window (the cable) might need to be replaced. To replace the cable, the door panel needs to be removed.
You may be referring to instrument cables.
need diagram of focus electric windows 1999
Well mostly, an amplifier (pretty obvious) but to connect to it, a guitar cable.
The speedometer cable connection is on the transmission tail shaft housing, drivers side. They went electric (no cable) in 1988 in the trucks.
guitar to cable to amplifier there is a 1/4 stereo or mono jack you plug the cable into , from there plug the other end into the amplifier and press on
The early 700R4 transmissions had a cable drive speedo. Maybe you can swap the tail housing and gears over.
If an electric window on a Toyota MR2 goes down, but will not go back up, it has probably slipped off the track. There is a cable mechanism that operates the window. The door panel will have to be removed to repair the cable, or put in a new track.
You need a 3 conductor #10 cable. A #10 wire is rated at 30 amps.
The regulator needs replaced. They are run up and down by cables and plastic pulleys. There is a broken pulley, which is causing the cable to not operate correctly.