Much depends on where the installation will be used and the voltage of it, and the current it's got to carry.
Automobile connections - which are normally for 12 volts - can be spade connectors or bullet connectors or chocolate block connectors.
Mains connections are made using junction boxes or chocolate block connectors.
But the above are in addition to the connections within the item to be connected, which normally has a hole that the wire goes into and a small screw that tightens onto the wire to stop it coming out.
<><><>
As always, if you are in doubt about what to do, the best advice anyone should give you is to call a licensed electrician to advise what work is needed.
Before you do any work yourself,
on electrical circuits, equipment or appliances,
always use a test meter to ensure the circuit is, in fact, de-energized.
IF YOU ARE NOT ALREADY SURE YOU CAN DO THIS JOB
SAFELY AND COMPETENTLY
REFER THIS WORK TO QUALIFIED PROFESSIONALS.
The wires should be twisted together, then a wire nut of the correct size needs to be twisted on then place a wrap of electrical tape around it, half on the wire and half around the nut. Also, you should wrap a light switch and outlet with tape so if it is removed and the power is on it does not come in contact with the box and short.
You need a 3 conductor #10 cable. A #10 wire is rated at 30 amps.
You take a wire and stick it to the positive end of the batter. Then connect another wire to the negative end of the battery. Connect both wires to the lightbulb.
it is the earth wire
you take the blue wire and connect it with the red then connect it to the yellow then you cut the green wire and there you go!
Depends on the Amperage of each baseboard heater (how many watts each one draws).
Yes, that is correct.
You need a 3 conductor #10 cable. A #10 wire is rated at 30 amps.
The electric choke wire connects to the electric choke assembly on the carburetor. It's a round, black plastic assembly that is on the side of a STOCK carburetor. There SHOULD be a connection on the "HOT" side of the coil that lets you connect the choke wire.
You would want a source that is live when the key is in the on position.
1. Run a wire from a battery to a lightbulb or something that measures electric current. 2. Connect a wire to the other part of the lightbulb/electric current measuring thing. 3. Connect a wire to the other part of the battery. 4. Connect the unused ends of the wires to the test substance or to each other for the control. If the lightbulb is bright or if the electric current measuring thing gives a similar result to the control, then the substance is a good conductor.
who invented electric wire
a battery is a acid full piece of medal that helps electric powered things when you connect wire on each side.
how do you connect the wire from the alternater to the starter?
Connect the sub woofer to the equalizer or amplifier. The positive wire will need to be connected to a power source. Connect the ground wire. Connect the auxiliary wire to the amplifier.
You take a wire and stick it to the positive end of the batter. Then connect another wire to the negative end of the battery. Connect both wires to the lightbulb.
Don't connect the red wire or you will die.
I connect the red wire to the blue wire to deactivate a bomb.