answersLogoWhite

0


Best Answer

there is one wire with a round connector, it goes on the lug, the other connectors are unique wire connectors and can only go one place, just match them up.

User Avatar

Wiki User

9y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you connect starter wires on a Mazda 2.2 B2200?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How many wires connect to a Nissan pickup starter?

2 wires


Why would bundling spark plug wires 2 3 and 4 in '91 Mazda B2200 quickly cause them to literally burn up?

cheap wires


Where is the starter solenoid located on a 1997 Mazda mpv?

the solenoid is on the starter. It's the part the wires go into.


Where is the starter relay located on a 1994 Buick Regal Custom?

On the top of the starter where wires connect


Why would my Tahoe try to start when you connect the battery WITHOUT a key in the ignition?

Did you just put a starter on it ??? Sounds like the starter wires are on the starter wrong are thay are shorted out. CHECK THE WIRES GOING TO THE STARTER CLOSELY.


Where is the starter located on a 1995 Mustang?

The Starter on a 1995 Mustang THe starter is located at the bottom of the engine near just off the flywheel. Disconnect the battery, then the wires going to the starter, unbolt the old starter, bolt in the new starter, attach the wires, connect the battery and you're done.


How do you hookup a starter 350 Chevy?

There's two wires to connect... just put them where they belong. Positive to the solenoid, negative to the starter body.


What wires coming off the firewall connect to the alternator and starter on a 1985 Silverado truck?

about 2 wires with fusible links in them running from divers firewall to passenger side starter behind engine block.


How do you bypass the starter solenoid?

Remove the lighter gauge wires from the solenoid, and connect full battery power (cable) directly to to the positive post on the starter motor.


How do you replace a starter in 1993 Chevy Caprice classic?

Disconnect the battery. Remove the wires from the starter then unbolt it. Lower the starter, then fit the new one in. Bolt up the starter and connect the wiring. Reconnect the battery.


How do you reset the check engine light on an 1989 Mazda B2200 after 120000 miles?

Look on the drivers side under the dash on the left hand side and you will see three wires two are connected just switch two of the wires and the light will go off.


What does it mean when you Replace starter and when you go to connect cables to battery the starter starts and stays on without key in ignition until you remove cable from battery?

The wires to the starter are probably connected wrong.