You can check out the related link below.
The answer is 398.15 K (approx.). The Kelvin scale starts at absolute zero and is used in scientific laboratories. Celsius is for general use and set 0 and 100 as melting and boiling point of water respectively. To convert from C to K, add 273.15 to C.
Conversion formula: [K] = [°C] + 273.15 = 0 + 273.15 = 273.15 K
The answer is -186.15 C (approx.). The Kelvin scale starts at absolute zero and is used in scientific laboratories. Celsius is for general use and set 0 and 100 as melting and boiling point of water respectively. To convert from K to C, subtract 273.15 from K.Subtract Kelvin minus 273.15 to convert to Celsius.
The answer is 248.15 K (approx.). The Kelvin scale starts at absolute zero and is used in scientific laboratories. Celsius is for general use and set 0 and 100 as melting and boiling point of water respectively. To convert from C to K, add 273.15 to C.
The answer is 289.15 K (approx.). The Kelvin scale starts at absolute zero and is used in scientific laboratories. Celsius is for general use and set 0 and 100 as melting and boiling point of water respectively. To convert from C to K, add 273.15 to C.
You dont. Minimum C is about maximum B. And the indentation is different. Even if you could convert it, the results would not be accurate.
Approx 37.8 Rockwell "c" scale
Diamond is more than 1000 times harder than quartz, which is in the 80 range in the Rockwell C. Diamond cannot be measured on the Rockwell C scale. A diamond pyramid is actually used in the Rockwell C test, which would be inconclusive.
RC stands for Rockwell Hardness C scale; the different letters A,B,C etc. are based on different loads and indenters for measurement. C scale is typical for steels, while B scale is typical for aluminum. There are conversion tables for these if needed.
Rockwell C scale
You can't. It's a different test method.
HRC stands for Hardness Rockwell C scale. There are different scales; C is probably the most common for hardened materials. See the related link for more information.
It can't be accurately converted.The softest metal on the C scale gets a 1 rating.That 1 rating is the equivalent of 82 on the B scale, which is the Rockwell scale used for copper.Copper and all it's alloys are down around the 40 range of the B scale.And you can't assume that a B scale 40 is half of a C scale 1, either. Since the tests use different metal ball sizes, it's an issue of being an unequal scale.
This is a method used to determine the hardness of a metal. If you know the type of metal and the hardness, this will tell you the Tensile Strength of the metal and how well it was heat treated. The method uses a ball or a pin to strick the metal and leave a small indention. The size and depth that the ball makes in the metal is inversely proportional to the hardness. Using the scale, you can then determine if the part has completed the proper heat treatment as required by the Engineering drawing. There are 3 Rockwell scales: A, B, C. Rockwell C scale is for the hardest of metals such as steel. Rockwell B is for metal such as soft aluminum and A is for even softer metals.
To convert any temperature to the kelvin scale, when its in oC add on 273. so in answer to your question, -146oC = 127K
-146 deg C = 127.15 K
F = 1.8C + 32 or conversely C = (F - 32)/1.8