0
More detailed information needed. The word flush used as a woodworking term means 'just touching'. You need to tell us where it is on the house . Do you mean an external weatherboard, or a skirting board, or an architrave or what. Do you mean the board is flush with a wall and you want to remove part of it, or, do you mean you want the board to finish up being flush with some part of a wall. More info. Please.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
What are in wall speakers?
Speakers mounted flush to a wall.
What is flush mounted electrical installation?
In this case, flush means even with. For example an electric box could be mounted on the outside of your wall and would be an eyesore. Flush mounting recesses the box inside the wall and provides a flush mount for the outlet cover plate.
What mineral's primary use is for wall board?
Gypsum is used for wall board.
Can you dip after wizdom teeth get cut out?
Yes jus flush well after
When hanging wallpaper do you cut or wrap around corner trim pieces?
When hanging wallpaper, you should cut the wallpaper flush with the corner trim piece. It is important to ensure that you start the first piece of wallpaper on each wall perfectly straight to avoid compounding angles as you move along.
How do you secret nail?
Secret nailing of tongue in groove boards is done by starting the nail at the junction of the top of the tongue and the edge of the board, and driving it on an angle into the thicker part of the board and down into the supporting timber beneath. These nails will be concealed by the groove of the next board as it seats over the tongue. A punch will be needed to drive the nail head flush into the board without damaging the board or tongue. In some timbers it is advisable to pre-drill a hole at a slightly smaller diameter than the nail in order to prevent the nail from splitting the board. In some furniture work and cabinetry, when a fixing is to be concealed, a chisel is used to partially cut a small shallow piece of timber (rectangular in shape, with a tapering underside and left fully attached on the opposite side to the start of the cut). This is carefully lifted up far enough to allow a screw, pin or nail to be fixed in the bottom of the cut. Then glue is applied in to cut and the piece of timber is pressed down flush, and sanded once the glue has dried. The cut made is just big enough to allow the fixing to be placed underneath.
Do you cut back Lilies after blooming?
If you cut the main flower back to the buds on the stem you will get a second flush of flowers.
How do you cut a pyramid out of poster board?
How to make a pyramid out of poster board?
Flush type and surface type switches?
surface type switches is a switches in the wall while flush type switches is connected in the outlet of appliances. this is the best answer for that!
Calculate projection of a window from the exterior wall finish?
The window frame should be flush with the exterior wall cladding.If the frame is in negative to the interior wall linings,then you will need to pack out flush with those linings.The sill of the window must project past the line of the exterior cladding by at least 40mm-50mm.
What object can compare to a cell wall?
The Cell Wall basically compares to a very strong board of wood. Because the cell wall's job is to provide structural support. A board of wood can to. (if its strong enough)
What are examples of manufactured board?
Cardboard, chip board, plywood, gypsum wall board, wall panelling.
