0
You can't really or rather you probably shouldn't. They are hollow and the bottom cut edge will rust no matter what you do to it. Normally, you would make the opening taller. If you had to, cut it with an abrasive blade in a circular saw if possible. This will give you a more even cut. I would either cut a board to fit inside the door and glue it in place, or clamp a 2x4 on either side across the face of the door, making sure thickness of the door was the same in the middle and put spray foam insulation in the bottom. Up at least 6 inches. Trim off the excess that comes out after it has hardened. This should seal the door and glue the two faces together.
What else can I help you with?
Can an angle grinder cut a hinge off of a door?
A angle grinder with a metal cut-off wheel can easily cut off a metal hinge. Use eye protection and be prepared for sparks.
Builtin cabinet from family room into garage what is the best fire rated 2-4 door to use to seal off cabinet?
A hollow metal exterior door should give you a one hour fire rating.
How can I replace the weatherstripping on an exterior door?
To replace weatherstripping on an exterior door, first remove the old weatherstripping by peeling it off or using a putty knife. Measure the dimensions of the door frame and cut the new weatherstripping to fit. Install the new weatherstripping by pressing it into place along the edges of the door frame. Make sure it creates a tight seal to prevent drafts and energy loss.
How do you remove and install a exterior door handle on a 1999 explorer XLT drivers side door?
Your going to have to take off the door panel. After you do that you will be able to see the door handle held in by rivets that have a metal that is bent out to hold it in place. Your going to have to bend them straight to get the handle out. Better off going to the dealer where they have the correct tool for it. I had the same problem on the same door. Goodluck
How do you remove exterior door handle 1961 VW Beetle?
There are 2 screws on the inside of the door under the door seal, remove and slide the door handle off.
How do you replace the driver's side exterior door mechanism on a 1998 Ford E350 van?
It isn't easy. It bolts on from the inside of the door. TAke the door panel off.
If you cut your finger in the car door and the tip was cut off what kind of wound you have?
A avulsion
What type of wound might you have if you cut your finger in the car door and the tip was cut off?
Avulsion
How do you take a door off?
On the hinges on the exterior of the vehicle there should be a nut that you have to unscrew from the door. after you have both nuts unscrewed (theres 2 on each door) open the door, roll the window down (i do this go hold the door better) then just pop the door up and it comes off the hinges.
How much can you cut off a hollow core door?
You can typically cut up to 1 inch off the bottom of a hollow core door. Be sure to measure carefully and use the appropriate tools to ensure a clean and precise cut.
America wanted to end Japans aggression by placing a to cut off the oil and scrap metal supply?
They wanted to place an embargo to cut off the supply of oil and scrap metal.
IF your car door handle will not open from the inside how do you fix it?
Take off the door panel. the plastic clip that holds the metal rod to the door handle came off or broke off. replace it.
