Use the key fob and press the "unlock" button. If you don't have the key fob, you'll need to have the vehicle towed to a dealership where you can get a new one.
Disabling the keyless ignition security lock on a 2007 Saturn can be done by programming the security locks. Turn the ignition to run, without actually starting the engine, and press the unlock switch for eight seconds.
Another way to disable the service engine soon light is to disconnect the battery for about 10-20 minutes.The most common reason for the service engine soon light to come on is that the gas cap wasn't tightened all the way.
32 and 2132 and 21
turn on the car but (ready to start) then one press on remote control open then close
engine diagram for a 1993 saturn
No.
There may be problem with you car's communication line between the Power Control Module (PCM) and the Body Control Module (BCM). There could also be a problem with the theft deterrent system. If the computer does not receive a signal from the security system, then it assumes that that it is being tampered with and will not allow the engine to be started. Have th car towed to GM dealership where a factory trained technician can properly diagnose the problem.
you really shouldn't disable that light. whenever you get the problem fixed the light will go out on its own. should you disable it you have no way of knowing of any problems your engine may have in the future.
There is a warning light which flashes when the engine begins to overheat.
1990 Mazda 323:The check engine light intermittently flashes a series of long and short intervals. A long flash is followed by 5 short flashes. Then another long flash is followed by 7 short flashes, a pause, and 9 more short flashes. How should I interpret this code?
By reprogramming the engine ECM.
Cycle the ignition on/off/on/off/on and count the flashes of the check engine light. A pattern of two flashes, pause, two flashes would be a code 22.