If it is the same as the Renault Laguna, then with the ignition on and the car stationary turn the headlight stalk from 0 (off) to the sidelights (lightbulb) posistion twice consecutively. You should then hear an audible signal and a meesage will appear on the information display. Repeat the proceedure to enable.
Assuming its a Scenic 2 2003 -2009..
Its not the same as the Laguna - You get into the car, insert the card, but dont touch the pedals. All your electrics will come on. Press and hold the Auto button at the end of the indicator stalk, you will hear a beep and it comes up on the display auto lights de-activated. To re-enable you just do it again, but i think it has 2 beeps when activating, and display says auto lights activated.
You've left your lights on!
A gearbox problem on a Renault Scenic Automatic could mean something as simple as cleaning the transmission screen. There are many things that could be going on. If the warning lights come on after the vehicle is driven for a while, it could be that the transmission is overheating due to low fluid. A mechanic will have to look at it to determine the extent of the malfunction.
Its all in the lights! the mark 1 has smaller headlights with the indicators to the side.
Type your answer here... all new modles have interior bult lights, this means you have to go two a Renault dealer hope this helps you out.
yes, you have two run a wire from the ignition where the lights are and connect it two the battery, this will power it with out the emobiliser acting as the switch...
you have to remove the rear lights then with a small screwdriver prise the clip off then just pull strut off
make sure the lids of the storage compartments in the floorwell are closed properly
was changing number plate bulb when the side lights on the drivers side front and back don't work brake lights indicators fog all work main beam at front works just no side lights
Not sure if this works the same way as the Megane, but here goes. Put your key card in the ignition slot and press start. Do not press the clutch or brake. Press and hold in the button at the end of the light stalk for about 5 seconds, or untill it bleeps twice. This should re activate the auto lights. Well at least it worked for me
Answerapply the parking brake before turning the ignition/starting the motor. OK, so how do you reengage it?
To disable the running lights either unplug the relay to the fuse box. Also there is a fuse for this in the fuse box remove this and that will disable the lights.
Turn the car off. push on the parking brake 1 or 2 clicks turn car on. the lights will not come on