answersLogoWhite

0


Best Answer

I am assuming you mean how do you remove the water pump because you don't want to take the water pump apart since you cannot get parts for it. To remove the pump for replacement:

Water pump removal (V6)

  1. Disconnect the negative battery cable at the battery.
  2. To get enough clearance, remove the radiator and coolant hoses from the pump.
  3. Remove the fan and clutch assembly.
  4. Loosen the alternator mounting bolts and drive belt. On some models, you may have to remove the alternator completely to get to the water pump bolts. Also you may have to remove the accessory drive belt pulley or tensioner and possibly the air conditioner compressor for the same reason. DO NOT REMOVE THE REFRIGERANT LINE FROM THE COMPRESSOR.
  5. Remove the Water pump pulley.
  6. Remove the bolts from the water pump noting what position the bolts are (Because of the different lengths) and remove the pump.
  7. Remove all the gasket material from the surface on the front cover.
  8. Install the new pump with 2 bolts, and then install all the bolts finger tight.
  9. Working around the pump, tighten the bolts to proper torque.
  10. Install the water pump pulley, and alternator and bracket if it was removed.
  11. Install the radiator and connect the hoses.
  12. Install all the belts and adjust to proper tension.
  13. Install the fan and clutch assembly.
  14. Connect the battery.
  15. Fill the cooling system.
  16. Start engine and check for leaks.
User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you disasemble the water pump on a 92 ford aerostar?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

1995 Ford Aerostar water pump removal V6 3.0L non AWD?

Removal of the water pump on a 1995 Ford Aerostar V6 3.0 non AWD begins by removing the drive belts and accessories. The water pump can then be unbolted and pulled from the engine.


Where is the Fuel pump relay located on a 97' Ford Aerostar XLT?

The fuel pump on a 1997 Ford Aerostar XLT is located on right side under the battery. This is connected to the back wall.


Where is the fuel pump on a 1989 Ford Aerostar?

It is inside the fuel tank.


What is the purpose of a weep hole on the water pump on a Ford Aerostar 1989?

The weep hole is "an indicator of bad bearings and/or seals" in the water pump when antifreeze starts to drip or run out of it. If antifreeze is coming out the weep hole, change the water pump.


Where is the fuel pump on a 1992 ford aerostar van?

The electric fuel pump is inside the fuel tank


Ford Aerostar fuel pump?

Believe it or not it's inside the gas tank.


Where is the fuel pump reset switch on a 1993 Ford Aerostar XL?

On the 1989 Aerostar it is under the dash near the passenger door.


How do you replace the water pump on a 1996 Ford Aerostar?

Remove radiator, serpentine belt, bracket for power steering, and you should be able to get to all water pump bolts, although I'm having a hard time removing fan from pump.


What might cause a 1993 Ford Aerostar to overheat?

Needs coolant and/or needs to be put back in timing/slack belt/deffective water pump.


Where is the water pump locatated on an aerostar?

the water pump is located right in the front of the engine right underneath the fan


How to take off powersteering pump off 2001 ford aerostar 3.8 van?

pump has to be pressed off with a puller.


How do you replace the water pump on a 1995 Ford Aerostar XL 3.0L?

after you remove the fan and fan hood remove the belt and the alternator. you then remove the 6mil bolts and your water pump should come free from the timing chain cover.