answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: How do you disasimble a upper control arm bushing on a 1994 gmc sonoma 2 WHEEL DRIVE?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you know when the control arm bushing is bad on a Chevy Malibu?

One way to know that a control arm bushing is bad on a Chevy Malibu is from the noises you will hear when you are driving. You will hear a clunking sound. The steering on the car will also not be as good as it once was. You could also experience drifting of the car as you drive.


Replacing sway bar bushings ford e250?

use airchisel to remove bushing then threaded rod with two big, thick washer to compress bushing . take socket to drive bushing in with maul and used some bearing grease to assist in install , dropping passenger side control arm makes it easier. what knuckles


Is a GMC sonoma front or rear wheel drive?

LOL rear wheel drive


Where is Sonoma wine county?

Sonoma wine county is located is a short drive North of the Golden Gate Bridge in California.


How long does it take to drive from Napa to Sonoma?

25 min B-)


Where is the jack on a 2000 gmc sonoma?

I drive a 2000 gmc sonoma. My jack is behind the passenger seat in a built in box. Hope this helps.


What supports the slip yoke of a one piece drive shaft assembly?

The tailshaft housing and bushing


Remove drive shaft on 93 sonoma?

unbolt it at each of the universal joints


What happens when the front bushings are gone?

my front arm bushing gone on the front right will it hurt to drive it


Why is there a squeaking noise when driving a Kubota rtv?

The squeak is caused by lack of lubrication to the steering bushing. Pull the steering wheel off. There is a rubber bushing that surrounds the steering shaft. Remove the bushing with a thin screwdriver. Once removed clean the bushing and shaft. Then add anti seize lube to the shaft and and bushing. Then use a 7/8 " deep socket to drive the bushing back into the steering housing. Clean and add anti seize lube to the bottom of the steering wheel . Then install the steering wheel.


How do you replace the roller bushing pins in a 2003 trailblazer polaris 250 drive clutch?

i would leave it alone.


How far is 1119 rimrock drive napa valley ca to sonoma California?

36 miles